Related Questions

The velocity ratio in case of an inclined plane inclined at angle 'θ' to the horizontal and weight being pulled up the inclined plane by vertical effort is
A sinθ
B cosθ
C tanθ
D cosecθ
A body of weight 'W' is required to move up on rough inclined plane whose angle of inclination with the horizontal is 'α'. The effort applied parallel to the plane is given by (where μ = tanφ = Coefficient of friction between the plane and the body.)
A P = W tanα
B P = W tan (α + φ)
C P = W (sinα + μcosα)
D P = W (cosα + μsinα)
Least force required to draw a body up the inclined plane is W sin (plane inclination + friction angle) applied in the direction
A Along the plane
B Horizontally
C Vertically
D At an angle equal to the angle of friction to the inclined plane
A body will begin to move down an inclined plane, if the angle of inclination of the plane is ________ the angle of friction.
A Equal to
B Less than
C Greater than
D None of these
A body will begin to move down an inclined plane if the angle of inclination of the plane is _________ the angle of friction.
A Equal to
B Less than
C Greater than
D None of these
When a tank containing liquid moves with an acceleration in the horizontal direction, then the free surface of the liquid
A Remains horizontal
B Becomes curved
C Falls on the front end
D Falls on the back end
The range of projectile on a downward inclined plane is ________ the range on upward inclined plane for the same velocity of projection and angle of projection.
A Less than
B More than
C Equal to
D None of these
If the direction of projection bisects the angle between the vertical and the inclined plane, then the range of projectile on the inclined plane is
A Zero
B Maximum
C Minimum
D None of these
The direction of projection should bisect the angle between the inclined plane and the vertical for a range of a projectile on inclined plane
A To be zero
B To be maximum
C To be minimum
D None of these
The mixing vat in a factory receives liquid ingredients through six separate value--- labeled R.S.T.U,Y and Z -- each of which has exactly two settings: open and closed.The mixing vat operator must ensure that each valve is set open or closed according to the following conditions: If T is open, both S and Z must be closed, R and Z cannot both be closed at the same time; If Y is closed, Z must also be closed;S and U cannot both be open at the same time. If Z is open, which of the following must be true?
A S is open
B T is open
C U is open
D y is open

Next steps