Related Questions

A semicircular disc rests on a horizontal surface with its top flat surface horizontal and circular portion touching down. The coefficient of friction between semi circular disc and horizontal surface is µ. This disc is to be pulled by a horizontal force applied at one edge and it always remains horizontal. When the disc is about to start moving, its top horizontal force will
A Remain horizontal
B Slant up towards direction of pull
C Slant down towards direction of pull
D None of the above
An open tank containing liquid is moving with an acceleration on an inclined plane. The inclination of the free surface of the liquid will be __________ to the acceleration of the tank.
A Equal to
B Directly proportional
C Inversely proportional
D None of these
A tank filled partially with a liquid is subjected to a uniform horizontal acceleration. Which of the following is true for the surface of liquid in the tank?
A The liquid surface falls down on the direction of motion and rises up on the back side of the tank
B The liquid surface falls down only at the center of the tank
C The surface of the liquid remains horizontal
D None
Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter)
A 0.5 D
B D
C 1.5 D
D 2 D
Two tanks are filled to capacity with automobile fuel. The first tank holds 600 gallons more than the second tank. If 100 gallons were to be pumped from each tank, the first tank would then contain 3 times as much fuel as the second tank. What is the total number of gallons of fuel in the two full tanks?
A 1,400
B 1,200
C 1,000
D 900
A tank is fitted with 8 pipes, some of them that fill the tank and others that are waste pipe meant to those that empty the tank can empty it in 6 hours. If all the pipes are kept open when the tank is full, it will take exactly 6 hours for the tank to empty. How many of these are these are fill pipes?
A 2
B 4
C 6
D 5
An empty fuel tank of a car was filled with A type petrol. When the tank was half-empty, it was filled with B type petrol. Again when the tank was half-empty, it was filled with A type petrol. When the tank was half-empty again, it was filled with B type petrol. What is the percentage of A type petrol at present in the tank?
A 33.5%
B 37.5%
C 40%
D 50%
An empty fuel tank of a car was filled with A type petrol. When the tank was half-empty, it was filled with B type petrol. Again when the tank was half-empty, it was filled with A type petrol. When the tank was half-empty again, it was filled with B type petrol. What is the percentage of A type petrol at present in the tank ?
A 33.5%
B 37.5%
C 40%
D 50%
If a vessel containing liquid moves downward with a constant acceleration equal to ‘g’ then
A the pressure throughout the liquid mass is atmospheric
B there will be vacuum in the liquid
C the pressure in the liquid mass is greater than hydrostatic pressure
D none of the above
Two taps A and B can fill a tank in 5 hours and 20 hours respectively. If both the taps are open then due to a leakage, it took 30 minutes more to fill the tank. If the tank is full, how long will it take for the leakage alone to empty the tank ?
A 4.5 hrs
B 7 hrs
C 18 hrs
D 36 hrs

Next steps