Related Questions

When an open coiled helical compression spring is subjected to an axial compressive load, the maximum shear stress induced in the wire is (where D = Mean diameter of the spring coil, d = Diameter of the spring wire, K = Wahl's stress factor and W = Axial compressive load on the spring)
A $$\frac{{{\text{WD}}}}{{\pi {{\text{d}}^3}}} \times {\text{K}}$$
B $$\frac{{2{\text{WD}}}}{{\pi {{\text{d}}^3}}} \times {\text{K}}$$
C $$\frac{{4{\text{WD}}}}{{\pi {{\text{d}}^3}}} \times {\text{K}}$$
D $$\frac{{8{\text{WD}}}}{{\pi {{\text{d}}^3}}} \times {\text{K}}$$
The stress induced in a body, when suddenly loaded, is _________ the stress induced when the same load is applied gradually.
A Equal to
B One-half
C Twice
D Four times
A plate with an elliptical hole in the centre, with semi-major axis (a) perpendicular to the direction of loading and semi-minor axis (b) along the direction of loading, is subjected to a pull P. The maximum stress induced at the edge of the hole is equal to (where $$\sigma $$ = Stress for a plate with no hole i.e. nominal stress)
A $$\sigma \left( {1 + \frac{{\text{b}}}{{2{\text{a}}}}} \right)$$
B $$\sigma \left( {1 + \frac{{2{\text{a}}}}{{\text{b}}}} \right)$$
C $$\sigma \left( {1 + \frac{{\text{b}}}{{3{\text{a}}}}} \right)$$
D $$\sigma \left( {1 + \frac{{3{\text{a}}}}{{\text{b}}}} \right)$$
In a steam engine, one method of obtaining the earlier cut-off with a simple slide valve is by increasing the angle of advance of the eccentric while the throw of the eccentric, steam lap and exhaust lap are kept constant. This method will
A Cause withdrawing or throttling of steam
B Reduce length of effective stroke of piston
C Reduce maximum opening of port to steam
D All of these
The design stress, which is more than the damaging stress, is the least unit stress that will render a member unfit for service before the end of its normal life. The design stress factor or factor of safety indicates the margin between design stress and the __________ stress.
A Working
B Damaging
C Allowable
D None of these
The stress induced in a body will be shear stress, when it is subjected to
A Longitudinal vibrations
B Transverse vibrations
C Torsional vibrations
D None of these
When a bolt is subjected to an external load, the stress induced in the bolt will be
A Tensile stress
B Shear stress
C Combined tensile and shear stress
D Any one of these
When an open coiled helical compression spring is subjected to an axial compressive load, the stress induced in the wire is
A Tensile stress
B Compressive stress
C Shear stress
D Bending stress
The direct stress induced in a long column is __________ as compared to bending stress.
A Same
B More
C Less
D Negligible
The stress in the bar when the load is applied suddenly is __________ as compared to the stress induced due to gradually applied loads.
A Same
B Double
C Three times
D Four times

Next steps