Related Questions

The stress induced in a body due to suddenly applied load compared to when it is applied gradually is
A Same
B Half
C Two times
D Four times
The stress in the bar when the load is applied suddenly is __________ as compared to the stress induced due to gradually applied loads.
A Same
B Double
C Three times
D Four times
The strain energy stored in a body, when suddenly loaded, is __________ the strain energy stored when same load is applied gradually.
A Equal to
B One-half
C Twice
D Four times
The ratio of the stresses produced by a suddenly applied load and by a gradually applied load on a bar, is
A $$\frac{1}{4}$$
B $$\frac{1}{2}$$
C 1
D 2
The strain energy stored in a body due to suddenly applied load compared to when it is applied gradually is
A Same
B Twice
C Four times
D Eight times
In testing a pile by load test, pile platform is loaded with one and half times the design load and a maximum settlement is noted. The load is gradually removed and the consequent rebound is measured. For a safe pile, the net settlement (i.e. total settlement minus rebound) per tonne of test load should not exceed
A 10 mm
B 15 mm
C 20 mm
D 25 mm
When a load W is applied suddenly on a bar of cross-sectional area A, the stress induced in the bar will be
A $$\frac{{\text{W}}}{{\text{A}}}$$
B $$\frac{{\text{W}}}{{2{\text{A}}}}$$
C $$\frac{{2{\text{W}}}}{{\text{A}}}$$
D $$\frac{{3{\text{W}}}}{{\text{A}}}$$
When the axis of load lies in the plane of rivet group, then the most heavily loaded rivet will be the one which (where, Fa is the load shared by each rivet due to axial load and Fm is the shearing load due to moment in any rivet.)
A Is at the maximum distance from CG of the rivet group
B Is at the minimum distance from CG of the rivet group
C Gives the maximum angle between the two forces Fa and Fm
D Gives the minimum angle between the two forces Fa and Fm
The simply supported beam 'A' of length '$$l$$' carries a central point load 'W'. Another beam 'B' is loaded with a uniformly distributed load such that the total load on the beam is 'W'. The ratio of maximum deflections between beams 'A' and 'B' is
A $$\frac{5}{8}$$
B $$\frac{8}{5}$$
C $$\frac{5}{4}$$
D $$\frac{4}{5}$$
When an open coiled helical compression spring is subjected to an axial compressive load, the maximum shear stress induced in the wire is (where D = Mean diameter of the spring coil, d = Diameter of the spring wire, K = Wahl's stress factor and W = Axial compressive load on the spring)
A $$\frac{{{\text{WD}}}}{{\pi {{\text{d}}^3}}} \times {\text{K}}$$
B $$\frac{{2{\text{WD}}}}{{\pi {{\text{d}}^3}}} \times {\text{K}}$$
C $$\frac{{4{\text{WD}}}}{{\pi {{\text{d}}^3}}} \times {\text{K}}$$
D $$\frac{{8{\text{WD}}}}{{\pi {{\text{d}}^3}}} \times {\text{K}}$$

Next steps