Related Questions

In static loading, stress concentration is more serious in
A Brittle materials
B Ductile materials
C Brittle as well as ductile materials
D Elastic materials
The yield point in fatigue loading compared to that in static loading is less. The ratio of ultimate tensile strength to endurance limit of a material subjected to fatigue loading is
A 0.5
B 1
C 1.5
D 2
The design stress, which is more than the damaging stress, is the least unit stress that will render a member unfit for service before the end of its normal life. The design stress factor or factor of safety indicates the margin between design stress and the __________ stress.
A Working
B Damaging
C Allowable
D None of these
A plate with an elliptical hole in the centre, with semi-major axis (a) perpendicular to the direction of loading and semi-minor axis (b) along the direction of loading, is subjected to a pull P. The maximum stress induced at the edge of the hole is equal to (where $$\sigma $$ = Stress for a plate with no hole i.e. nominal stress)
A $$\sigma \left( {1 + \frac{{\text{b}}}{{2{\text{a}}}}} \right)$$
B $$\sigma \left( {1 + \frac{{2{\text{a}}}}{{\text{b}}}} \right)$$
C $$\sigma \left( {1 + \frac{{\text{b}}}{{3{\text{a}}}}} \right)$$
D $$\sigma \left( {1 + \frac{{3{\text{a}}}}{{\text{b}}}} \right)$$
Stress concentration in cyclic loading is more serious in
A Ductile materials
B Brittle materials
C Equally serious in both cases
D Depends on other factors
In cyclic loading, stress concentration is more serious in
A Brittle materials
B Ductile materials
C Brittle as well as ductile materials
D Elastic materials
The maximum stress due to stress concentration in a bar having circular transverse hole, as compared to its static stress without hole will be
A Same in both cases
B 2 times more
C 3 times more
D 4 times more
The yield point in static loading is __________ as compared to fatigue loading.
A Higher
B Lower
C Same
D None of these
Yield point in fatigue loading as compared to static loading is
A Same
B Higher
C Lower
D Depends on other factors
The permissible stress for carbon steel under static loading is generally taken as
A 2,000 - 3,000 kg/m2
B 3,000 - 4,000 kg/cm2
C 4,000 - 4,500 kg/cm2
D 7,500 - 10,000 kg/cm2

Next steps