Related Questions

For steel, the ultimate strength in shear as compared to ultimate strength in tension is
A $$\frac{1}{2}$$
B $$\frac{1}{3}$$
C $$\frac{1}{4}$$
D $$\frac{2}{3}$$
The ultimate strength in tension for steel is __________ times the ultimate strength in shear.
A 0.5
B 0.9
C 1.5
D 2.5
For steel, the ultimate strength in shear as compared to in tension is nearly
A Same
B Half
C One third
D Two third
Ultimate strength in tension as compared to that in shear for steel is
A Half
B One third
C One and half times
D One fourth
The ultimate tensile stress for mild steel is __________ the ultimate compressive stress.
A Equal to
B Less than
C More than
D None of these
The ultimate tensile stress of mild steel compared to ultimate compressive stress is
A Same
B More
C Less
D Unpredictable
When the belt is stationary, it is subjected to some tension known as initial tension. The value of this tension is equal to the
A tension in the tight side of the belt
B tension in the slack side of the belt
C sum of the tensions on the tight side and slack side of the belt
D average tension of the tight side and slack side of the belt
When a hole of diameter ‘d’ is punched in a metal of thickness 't', then the force required to punch a hole is equal to (where $${\tau _{\text{u}}}$$ = Ultimate shear strength of the material of the plate)
A $${\text{dt}}{\tau _{\text{u}}}$$
B $$\pi {\text{dt}}{\tau _{\text{u}}}$$
C $$\frac{\pi }{4} \times {{\text{d}}^2}{\tau _{\text{u}}}$$
D $$\frac{\pi }{4} \times {{\text{d}}^2} \times {\text{t}}{\tau _{\text{u}}}$$
The strain energy stored in a body due to shear stress, is (where $$\tau $$ = Shear stress, C = Shear modulus and V = Volume of the body)
A $$\frac{{\tau {\text{V}}}}{{2{\text{C}}}}$$
B $$\frac{{2{\text{C}}}}{{\tau {\text{V}}}}$$
C $$\frac{{{\tau ^2}{\text{V}}}}{{2{\text{C}}}}$$
D $$\frac{{2{\text{C}}}}{{{\tau ^2}{\text{V}}}}$$
Ultimate strength of cold drawn high steel wires
A Increases with increase in diameter of bar
B Decreases with increase in diameter of bar
C Does not depend on diameter of bar
D None of the above

Next steps