Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

From an alloy, two specimens are machined and tested separately under tension and compression. The engineering stress-strain curves as well as the true stress-true strain curves for tension and compression are plotted in the same diagram. Identify the correct statements:
P. The engineering stress-strain curves in tension and compression are identical.
Q. The true stress-true strain curve in compression is lower than the true stresstrue strain curve in tension due to Bauschinger effect.
R. The true stress-true strain curve in tension is above the corresponding engineering stress-strain, curve.
S. The true stress-true strain curve in tension and compression are identical.
The ultimate strength in tension for steel is __________ times the ultimate strength in shear.
Tresca or maximum-shear stress criteria assumes that yielding occurs when the maximum shear stress reaches a value of the shear stress in the uniaxial tension test. Assume the principal stress being σ1, σ2, σ3 where σ1 is largest, and σ3 is the smallest principal stresses. Find the value of minimum shear stress to cause yielding, given that yield stress in tension is equal to σo?
Check for ultimate shear strength such that shear force, Vu = 2834 kn, According to IRC: 18-2000, the ultimate shear resistance of the support section uncracked in flexure loss ratio is 0.8, p is 12000×103, area is 0.88 x 106mm2?
According to the International Commission on Education for the Twenty-first Century headed by Jacques Delors, which of the following main tensions will be witnessed during the 21st century ? A. The tension between the global and the local B. The tension between tradition and modernity C. The tension between the spiritual and the material D. The tension between the poor and the rich E. The tension between the developed and the developing societies Choose the correct answer from the options given below:
For steel, the ultimate strength in shear as compared to in tension is nearly
Ultimate strength in tension as compared to that in shear for steel is
Consider the following statements related to the merits of construction in structural steel: 1. Structural steel has high strength per unit weight as compared to RCC. 2. The steel members are slender or small in size as compared to RCC. 3. The steel structures are useful in the construction of tall buildings, long-span bridges, and airplane hangers. Which of the above statements are correct?
The ultimate shear force at a section of an RCC beam is 300 kN. The shear resisted by concrete is 77.5 kN. What is the shear for which shear reinforcement is required?
The ultimate strength of steel in tension in comparison to shear is in the ratio of