Related Questions

In an oil lubricated journal bearing, the coefficient of friction between the journal and the bearing
A Remains constant at all speeds
B Is minimum at zero speed and increases monotonically with increase in speed
C Is maximum at zero speed and decreases monotonically with increase in speed
D Becomes minimum at an optimum speed and then increases with further increase in speed
In a journal bearing, the load on the bearing is __________ to the axis of the journal.
A Parallel
B Perpendicular
C Both A and B
D None of these
In a partial journal bearing, the angle of contact of the bearing with the journal is
A 120°
B 180°
C 270°
D 360°
In a full journal bearing, the angle of contact of the bearing with the journal is
A 120°
B 180°
C 270°
D 360°
If p = bearing pressure on projected bearing area, Z = absolute viscosity of lubricant and N = speed of journal, then the bearing characteristic number is given by
A $$\frac{{{\text{ZN}}}}{{\text{p}}}$$
B $$\frac{{\text{p}}}{{{\text{ZN}}}}$$
C $$\frac{{\text{Z}}}{{{\text{pN}}}}$$
D $$\frac{{\text{N}}}{{{\text{Zp}}}}$$
The bearing characteristic number in a hydrodynamic bearing depends upon
A Length, width and load
B Length, width and speed
C Viscosity, speed and load
D Viscosity, speed and bearing pressure
When the length of the journal is equal to the diameter of the journal, then the bearing is said to be a
A Short bearing
B Long bearing
C Medium bearing
D Square bearing
In a boundary lubricated bearing, there is a __________ of lubricant between the journal and the bearing.
A Thick film
B Thin film
C Either A or B
D None of these
A sliding bearing which can support steady loads without any relative motion between the journal and the bearing, is called
A Hydrostatic lubricated bearing
B Hydrodynamic lubricated bearing
C Boundary lubricated bearing
D Zero film bearing
The usual clearance provided in hydrodynamic bearing per mm of diameter of shaft is
A 0.01 micron
B 0.1 micron
C 1 micron
D 10 microns

Next steps