Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Consider the following statements: 1. HSS tools wear very rapidly, whereas in cemented carbide tools, even though hardness is retained, crater wear can occur due to solid-state diffusion. 2. Cutting tools made of Super-HSS, also known as cobalt-based HSS, are made by adding 2% to 15% of cobalt which increases the cutting efficiency at heavier cuts by increasing the hot hardness and wear resistance. 3. Tools failure due to excessive stress can be minimized by providing small or negative rake angles on brittle tool materials, protecting tool tip by providing large side-cutting edge angles, and honing a narrow chamfer along the cutting edge. Which of the above statements are correct?
Two statements are given, followed by three conclusions numbered I, II and III. Assuming the statements to be true, even if they seem to be at variance with commonly known facts, decide which of the conclusions logically follow(s) from the statements. Statements: All equipments are screw-drivers. All machines are equipments. Conclusions: I. Some screw-drivers are equipments. II. Some screw-drivers are machines. III. All equipments are machines.
Arrange the correct sequence of cutting a sleeve pattern.
1. Marking the stitching line
2. Tracing the stitching line
3. Cutting the sleeve pattern
4. Marking the cutting line
Select the correct answer
Which equipments support primary equipments with support stations and support equipments?
World Bank has employed major dimensions to construct measures of governance. These dimensions are:
1. Voice and Accountability - measuring political, civil and human rights
2. Instability an d violence - measuring the likelihood of violent threats to or changes in government, including terrorism
3. Government effectiveness - measuring the competence of the bureaucracy and the quality of public service delivery
4. Regulatory burden - measuring the incidence of market, unfriendly policies
5. Rule of law - measuring the quality of contract enforcement, the police, and the courts, as well as the likelihood of crime and violence
Select the correct answer:
On some day, manufacturing unit A produces 78,868 toys, manufacturing unit B produces 87,868 toys, manufacturing unit C produces 88,768 toys and manufacturing unit D produces 67,888 toys. Which manufacturing unit is doing the second least production?
High speed steel cutting tools operate at cutting speeds _________ than carbon steel tools.
Flank wear occurs mainly on the 1. Nose part of the cutting tool 2. Front relief face and side relief face of the cutting tool 3. Face of the cutting tool at the shortest distance from the cutting edge Which of the above is/are correct?
Choose a figure which would most closely resemble the unfolded form of figure (Z).
Paper Cutting mcq question image
Choose a figure which would most closely resemble the unfolded form of figure (Z).
Paper Cutting mcq question image