Which command will clear all the translations active on your router?

A <code class="args"><em>show ip nat translations</em></code>
B <code class="args"><em>show ip nat statistics</em></code>
C <code class="args"><em>debug ip nat</em></code>
D <code class="args"><em>clear ip nat translations *</em></code>

Correct Answer: <code class="args"><em>clear ip nat translations *</em></code>

The command clear ip nat translations * will clear all the active NAT entries in your translation table.
Bissoy MCQ
#Networking #Network Address Translation

Related Questions

Which command will show you all the translations active on your router?
A show ip nat translations
B show ip nat statistics
C debug ip nat
D clear ip nat translations *
You save the configuration on a router with the copy running-config startup-config command and reboot the router. The router, however, comes up with a blank configuration. What can the problem be?
A You didn
B NVRAM is corrupted.
C The configuration register setting is incorrect.
D The newly upgraded IOS is not compatible with the hardware of the router.
Which command will allow you to see real-time translations on your router?
A show ip nat translations
B show ip nat statistics
C debug ip nat
D clear ip nat translations *
You need to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface of the router for this connection?
A Router (config-if) #encapsulation frame-relay q933a
B Router (config - if) #encapsulation frame-relay ansi
C Router (config - if) #encapsulation frame-relay ietf
D Router (config - if) #encapsulation frame-relay cisco
The corporate office sends you a new router to connect, but upon connecting the console cable, you see that there is already a configuration on the router. What should be done before a new configuration is entered in the router?
A RAM should be erased and the router restarted
B Flash should be erased and the router restarted
C NVRAM should be erased and the router restarted
D The new configuration should be entered and saved
You need to find the broadcast address used on a LAN on your router. What command will you type into the router from user mode to find the broadcast address?
A show running-config
B show startup-config
C show interfaces
D show protocols
If routers in a single area are configured with the same priority value, what value does a router use for the OSPF Router ID in the absence of a loopback interface?
A The Lowest IP address of any physical interface
B The Highest IP address of any physical interface
C The Lowest IP address of any logical interface
D The Highest IP address of any logical interface
Which command will show you the IOS version running on your router?
A sh IOS
B sh flash
C sh version
D sh running-config
You are troubleshooting a connectivity problem in your corporate network and want to isolate the problem. You suspect that a router on the route to an unreachable network is at fault. What IOS user exec command should you issue?
A Router>ping
B Router>trace
C Router>show ip route
D Router>show interface
You telnet to a router and make your necessary changes; now you want to end the Telnet session. What command do you type in?
A close
B disable
C disconnect
D exit

Next steps