Homogenization performed by passing the cells at high pressure through narrow orifice which can also cause cell rupture is referred to as . . . . . . . .

Homogenization performed by passing the cells at high pressure through narrow orifice which can also cause cell rupture is referred to as _______________

A

ultrasonicator

B

freezer

C

mortar and pestle

D

french press

The discharge through a small rectangular orifice is given by (where Cd = Coefficient of discharge for the orifice, a = Cross-sectional area of the orifice, h = Height of the liquid above the centre of the orifice)

A

Q = Cd × a × 2gh

B

Q = (2/3). Cd × a × h

C

Q = (Cd × a)/√(2gh)

D

Q = (3Cd × a)/√(2h)

The discharge through a wholly drowned orifice is given by (where H₁ = Height of water (on the upstream side) above the top of the orifice, H₂ = Height of water (on the downstream side) above the bottom of the orifice and H = Difference between two water levels on either side of the orifice)

A

$${\text{Q}} = {{\text{C}}_{\text{d}}} \times {\text{b}}{{\text{H}}_1}\sqrt {2{\text{gh}}} $$

B

$${\text{Q}} = {{\text{C}}_{\text{d}}} \times {\text{b}}{{\text{H}}_2}\sqrt {2{\text{gh}}} $$

C

$${\text{Q}} = {{\text{C}}_{\text{d}}} \times {\text{b}}\left( {{{\text{H}}_2} - {{\text{H}}_1}} \right)\sqrt {2{\text{gh}}} $$

D

$${\text{Q}} = {{\text{C}}_{\text{d}}} \times {\text{bH}}\sqrt {2{\text{gh}}} $$

The discharge through a small rectangular orifice is given by (where C_d = Coefficient of discharge for the orifice, a = Cross-sectional area of the orifice, h = Height of the liquid above the centre of the orifice)

A

$${\text{Q}} = {{\text{C}}_{\text{d}}} \times {\text{a}} \times \sqrt {2{\text{gh}}} $$

B

$${\text{Q}} = \frac{2}{3}{{\text{C}}_{\text{d}}} \times {\text{a}} \times {\text{h}}$$

C

$${\text{Q}} = \frac{{{{\text{C}}_{\text{d}}} \times {\text{a}}}}{{\sqrt {2{\text{gh}}} }}$$

D

$${\text{Q}} = \frac{{3{{\text{C}}_{\text{d}}} \times {\text{a}}}}{{\sqrt {2{\text{h}}} }}$$

The discharge through a large rectangular orifice is given by (where H₁ = Height of the liquid above the top of the orifice, H₂ = Height of the liquid above the bottom of the orifice, b = Breadth of the orifice and C_d = Coefficient of discharge)

A

$${\text{Q}} = \frac{2}{3} \times {{\text{C}}_{\text{d}}} \times {\text{b}}\sqrt {2{\text{g}}} \left( {{{\text{H}}_2} - {{\text{H}}_1}} \right)$$

B

$${\text{Q}} = \frac{2}{3} \times {{\text{C}}_{\text{d}}} \times {\text{b}}\sqrt {2{\text{g}}} \left( {{\text{H}}_2^{\frac{1}{2}} - {\text{H}}_1^{\frac{1}{2}}} \right)$$

C

$${\text{Q}} = \frac{2}{3} \times {{\text{C}}_{\text{d}}} \times {\text{b}}\sqrt {2{\text{g}}} \left( {{\text{H}}_2^{\frac{3}{2}} - {\text{H}}_1^{\frac{3}{2}}} \right)$$

D

$${\text{Q}} = \frac{2}{3} \times {{\text{C}}_{\text{d}}} \times {\text{b}}\sqrt {2{\text{g}}} \left( {{\text{H}}_2^2 - {\text{H}}_1^2} \right)$$

Which of the following statement(s) is/are CORRECT for antigen activated effector T cells?
P. CD4+ cells make contact with macrophages and stimulate their microbicidal activity.
Q. CD4+ cells make contact with B cells and stimulate them to differentiate into plasma cells.
R. CD8+ cells make contact with B cells and stimulate them to differentiate into plasma cells.
S. CD8+ cells make contact with virus infected cells and kill them.

A

Q only

B

Q and S only

C

P, Q and S only

D

P, Q, R and S

A rectangular orifice of 2 m width and 1.2 m deep is fitted in one side of large tank. The easier level on one side of the orifice is 3m above the top edge of the orifice while on the other side of the orifice the water level is 0.5 m below it’s top edge. Calculate discharge if Cd = .64

A

4.95 m3/s

B

5.67 m3/s

C

3.56 m3/s

D

6.75 m3/s

Name the theory of homogenization According to which homogenization takes place when the liquid is leaving the gap, so the back pressure which is important to cavitation is important to homogenization.

A

Cavitation theory

B

Eddies theory

C

Current theory

D

Voltage theory

The figure shows the cross-sectional diagram of an orifice flow meter with an orifice radius R. Point ‘a’ is 30 R upstream while points ‘b’ and ‘c’ are 0.8 R and 30 R downstream from the orifice respectively. The pressure at points a, b and c are PaPb, and Pc respectively. Then

A

P_c > P_b > P_a

B

P_b > P_c > P_a

C

P_a > P_b > P_c

D

P_a > P_c > P_b

A solid-oxide fuel cell is fed with carbon monoxide and reacts with air to produce CO2. This reaction will produce 2 electrons which are used to power an electric circuit external to the fuel cell. The reaction equation is shown below: 2CO(g) + O2(g) -> 2CO2(g) ΔHr° = -565.96 kJ/mol This reaction does not occur for other types of fuel cells which use a catalyst, such as polymerelectrolyte membrane or phosphoric-acid fuel cells. The presence of carbon monoxide on the anode side of these types of fuel cells will cause catalyst poisoning, reducing the efficiency and voltage of the fuel cell. Determine the rate of enthalpy change for a carbon dioxide production rate of 208 mol/hr. The extent of the reaction occurring in the fuel cell can be obtained by the following equation: where:

A

-16.35 kW

B

-15.35 kW

C

-16.45 kW

D

-15.45 kW

Homogenization performed by passing the cells at high pressure through narrow orifice which can also cause cell rupture is referred to as . . . . . . . .

Related Questions