Related Questions

A hollow shaft will transmit a __________ torque than a solid shaft of the same mass and same material.
A Smaller
B Greater
C Medium
D None of these
The frictional torque transmitted by a disc or plate clutch is same as that of
A flat pivot bearing
B flat collar bearing
C conical pivot bearing
D trapezoidal pivot bearing
The frictional torque transmitted by a cone clutch is same as that of
A flat pivot bearing
B flat collar bearing
C conical pivot bearing
D trapezoidal pivot bearing
The maximum torque multiplication ratio in a torque converter is about
A 2.5
B 10
C 25
D 40
Clutch facings are usually attached to the plate by
A Steel rivets
B Brass rivets
C Aluminium screws
D Steel screws
A survey was conducted among the students of Khulna University to find out how many forms of physical exercise usually swam, 25% said they usually did jogging, 20% said they played cricket, 15% said they usually played football and 20 respondents said they did not take any form of exercise. From the above findings it can be concluded that.
A The student of khulna University do not usually take physical exercise.
B No respondent took more than one form of exercise.
C The method of data collection was not valid.
D Some of the respondents took more than one form of exercise.
Generators for peak load plants are usually designed for maximum efficiency at
A 25 to 50 percent full load
B 50 to 75 percent full load
C full load
D 25 percent overload
Which of the following load normally needs starting torque more than the rated torque?
A Blowers
B Conveyors
C Air compressors
D Centrifugal pumps
The ratio of starting torque to full-load torque is least in case of
A Series motors
B Shunt motors
C Compound motors
D None of the above
The torque converter uses ________ to transfer torque.
A Air
B Automatic transmission fluid (ATF)
C Gears
D Steel belt

Next steps