Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

In an actual transformer the iron loss remains practically constant from noload to fullload because
What are the conditions to be satisfied by a voltage source for using it in switching regulator. i. It must supply the required output power and the losses associated with the switching regulator ii. It must be large enough to supply sufficient dynamic range line and load variations iii. It must be sufficient high to meet the minimum requirement of the regulator system to be designed iv. It may be required to store energy for a specified amount of time during power failure especially if the system is designed for a computer power supply.
A dc power supply has no-load voltage of 30v,and a full-load voltage of 25v at full-load current of 1A.Its output resistance & load regulation ,respectively are
Which of the following statements are correct for an ideal constant voltage source? 1. Its output voltage remains absolutely constant whatever the change in load current. 2. It possesses zero internal resistance so that internal voltage drop in the source is zero. 3. Output voltage is provided by the source would remain constant irrespective of the amount of current drawn from it. 4. Output voltage provided by the source varies with the amount of current drawn from it.
For a Zener diode shunt regulator, the source current is IS, the Zener diode current is IZ and the load current is IL. The source voltage is VS, Zener voltage is VZ and load voltage is VL. The load resistance is RL. What is the correct option for the safe operation of the diode?
A designer requires a shunt regulator of approximately 20 V. Two kinds of Zener diodes are available: 6.8-V devices with rz of 10 Ω and 5.1-V devices with rz of 30 Ω. For the two major choices possible, find the load regulation. In this calculation neglect the effect of the regulator resistance R.
The voltage regulation of a transformer at full-load 0.8 p.f lagging is 2%. Its voltage regulation at full load 0.8 p.f leading _____________
The voltage regulation of a transformer at full-load 0.8 p.f leading is -2%. Its voltage regulation at full load 0.8 p.f lagging _____________
Consider the following statement: 1. Initial load tests and routine load tests are carried out on test piles and working Piles, respectively. 2. In a pile load test, the allowable load can be taken equal to half the ultimate load at which the total settlement amounts to one-tenth of the pile diameter. 3. In a pile load test, the allowable load can be taken equal to two-thirds of the total toad which causes a plastic settlement of 6 mm. Which of the above statements are correct?
Find the difference between output current having a load of 100Ω and 120Ω for 7805 IC regulator. Consider the following specification: Voltage across the load = 5v; Voltage across the internal resistor= 350mv.