Related Questions

The speed characteristics of an induction motor closely resemble the speed-load characteristics of which of the following machines
A D.C. series motor
B D.C. shunt motor
C Universal motor
D None of the above
The drive-shafts are connected to the differential and wheel hubs through universal joints because the universal joints
A Absorb the vibrations transferred from the surface of the road
B Compensate for variations in the relative positions of the differential and the wheels which result from bumpy road surfaces or other similar driving conditions.
C Absorb any difference in speed between the left and right wheels when the vehicle is turning
D None of the above
Of the 120 households in an area, 55 have cars, 35 have motor bikes, and 20 have both cars and motor bikes. How many of the households in the area have neither cares nor motor bikes?
A 110
B 90
C 50
D 30
A motor pool has 300 vehicles of which 30% are trucks. 20% of all the vehicles in the motor pool are diesel, including 15 trucks. What percent of the motor pool is composed of vehicles that are neither trucks nor diesel?
A 165%
B 90%
C 65%
D 10%
By looking at which part of the motor, it can be easily confirmed that a particular motor is D.C. motor?
A Frame
B Shaft
C Commutator
D Stator
One D.C. motor drives another D.C. motor. The second D.C. motor when excited and driven
A Runs as a generator
B Does not run as a generator
C Also runs as a motor comes to stop after sometime
D None of these
Flywheel is used with D.C. compound motor to reduce the peak demand by the motor, compound motor will have to be
A Level compounded
B Under compounded
C Cumulatively compounded
D Differentially compounded
A synchronous motor installed at the receiving end substation operates with such an excitation that it takes power at lagging power factor. Now if the applied voltage of the synchronous motor goes down, the power factor of the synchronous motor will
A remain same
B go down
C improve
D none of the above
In case of high speed universal motor which of the following needs more attention ?
A End play
B Air gap
C Insulation in rotor
D Balancing of rotor
The speed control of universal motor used for sewing machines is by
A friction
B varying the resistance
C tapping the field
D centrifugal mechanism

Next steps