Related Questions

D.C. motor is to a drive a load which is almost nil for certain part of the load cycle and peak value for short duration. We will select this
A Series motor
B Shunt motor
C Compound motor
D Any of the above
You are about to install a second IDE hard drive in a PC that has only one IDE adapter. Your first hard drive will still be the boot drive. How should the second drive be configured?
A as a master
B as a secondary
C as a slave
D as a primary
E as auto-select
Flywheel is used with D.C. compound motor to reduce the peak demand by the motor, compound motor will have to be
A Level compounded
B Under compounded
C Cumulatively compounded
D Differentially compounded
Based on the information below, how much did a certain telephone call cost? 1. The call lasted 1 minute 27 seconds 2. The cost for the first 30 second unit is Tk. 1.80, call duration more than 30 seconds costs Tk. 0.90 per 30 second unit 3. Any call duration less than 30 seconds is rounded up to the nearest 30-second unit.
A Tk. 1.80
B Tk. 2.61
C Tk. 2.70
D Tk. 3.51
The duration of sudden short-circuit test on a synchronous motor is usually about
A one hour
B one minute
C one second
D none of the above
When the axis of load lies in the plane of rivet group, then the most heavily loaded rivet will be the one which (where, Fa is the load shared by each rivet due to axial load and Fm is the shearing load due to moment in any rivet.)
A Is at the maximum distance from CG of the rivet group
B Is at the minimum distance from CG of the rivet group
C Gives the maximum angle between the two forces Fa and Fm
D Gives the minimum angle between the two forces Fa and Fm
A synchronous motor is running on a load with normal excitation. Now if the load on the motor is increased
A power factor as well as armature current will decrease
B power factor as well as armature current will increase
C power factor will increase but armature current will decrease
D power factor will decrease and armature current will increase
In testing a pile by load test, pile platform is loaded with one and half times the design load and a maximum settlement is noted. The load is gradually removed and the consequent rebound is measured. For a safe pile, the net settlement (i.e. total settlement minus rebound) per tonne of test load should not exceed
A 10 mm
B 15 mm
C 20 mm
D 25 mm
A synchronous motor which works on a leading power factor and does not drive a mechanical load is called as
A static condenser
B condenser
C synchronous condenser
D none of the above
A motor pool has 300 vehicles of which 30% are trucks. 20% of all the vehicles in the motor pool are diesel, including 15 trucks. What percent of the motor pool is composed of vehicles that are neither trucks nor diesel?
A 165%
B 90%
C 65%
D 10%

Next steps