Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

A resistance R is measured using the connection shown in the below figure. The current measured is 10 A on ranges 100A and the voltage measured is 125 V on 150 V range. The scales of the ammeter and voltmeter are uniform. The total number of scale divisions of the ammeter is 100 and that of the voltmeter is 150. The scale division can be distinguished. The constructional error of the ammeter is ± 0.3% and that of voltmeter±0.4%. The resistance of the ammeter is 0.25 Ω. The possible error in the measurement of R is?
An ammeter has a resistance of G ohms and range of I amperes. The value of resistance required in parallel to convert it into an ammeter of range nI is ___________.
সিরিজে সংযুক্ত একটি এ্যামিটার এবং একটি অজানা রোধ দুটি একই রকম 1.5 V ব্যাটারীর দুই প্রান্তে সংযুক্ত আছে। যখন ব্যাটারী দুটি সিরিজে সংযুক্ত থাকে তখন এ্যামিটার। amp রিডিং প্রদর্শন করে। আবার ব্যাটারী দুটি সমান্তরালে সংযুক্ত করলে 0.6 amp রিডিং প্রদর্শন করে। ব্যাটারীর আভ্যন্তরিন রোধ কত ? (An ammeter and an unknown resistance are connected in series across two identical batteries of each 1.5 V. The ammeter shows current I amp and 0.6 amp when the batteries are connected in series and parallel, respectively. What is the internal resistance of the battery?)
Which Statements is / are correct ? A. An ammeter is connected in series in a circuit and a voltmeter is connected in Parallel. B. An ammeter has a high resistance C. A voltmeter has a low resistance
Consider the following statements regarding reciprocity theorem : 1. In any passive linear bilateral network, if the single voltage source Vx, in branch x produces the current response Iy, in branch y, then the removal of the voltage source from branch x and its insertion in branch y will produce the current response iy in branch x. 2. The interchange of an ideal voltage source and an ideal ammeter in any passive, linear, bilateral circuit will not change the ammeter reading. 3. The interchange of an ideal current source and an ideal voltmeter in any passive linear bilateral circuit will change the voltmeter reading. Which of the above statements are correct ?
A moving iron ammeter may be compensated for frequency errors by
The function of shunt in an ammeter is to
Power is measured in a three-phase load by using an ammeter.
The internal resistance of an ammeter should be
To measure the current out of the second resistor in a circuit consisting of four resistors, an ammeter can be placed