Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

As per IS 800 ∶ 2007, in the design of beams/plate girders, when the web of a member acting alone is inadequate, different types of stiffeners are provided. Match the type of stiffeners provided in List I with the requirement to be satisfied by them in List 2. (Use the Code in the lists for matching). List 1 List 2 B. Intermediate transverse web stiffener 1. Provide local reinforcement to web under shear and bearing. C. Load carrying stiffener 2. Improve the buckling strength of a slender web due to shear. D. Bearing stiffener 3. Prevent local buckling of web due to concentrated loading. E. Diagonal stiffener 4. Prevent local crushing of web due to concentrated loading
Consider the following statements: In a plate girder 1. Bearing stiffeners are designed for bearing forces and they must also be checked for safety against compressive forces. 2. The length of any staggered intermittent fillet weld should not be less than 10 times the thickness of the stiffener. 3. Bearing stiffeners must be provided at the point of maximum bending moment. Which of the above statements are correct?
Consider the following statements: 1. The thickness of the gusset plate should not be more than the thickness of the structural members being connected. 2. A plate girder is essentially a beam and its moment of resistance depends upon its section modulus. 3. The function of the flanges in a plate girder is to resist the bending moment and hence their respective areas can be reduced near the supports of a simply supported beam. Which of the above statements are correct?
Bearing stiffener in a plate girder is used to
In Sanjay Cafe, the charges for Maharashtrian meal plate is Rs. 45 and charges for South Indian meal plate is Rs. 60. In a particular month, 40 Maharashtrian meal plate were served while number of South Indian meal plate served was 65, then what is the ratio of total charges collected for Maharashtrian meal plate and total charges collected for South Indian meal plate?
Rinki has three plates of Jalebies: Plate A, Plate B and Plate C. Plate A has only one Jalebi, Plate B has five Jalebies and Plate C has three Jalebies. She wants to put equal numbers of Jalebies in all the plates. Which of the following statement is true?
A semicircular disc rests on a horizontal surface with its top flat surface horizontal and circular portion touching down. The coefficient of friction between semi circular disc and horizontal surface is µ. This disc is to be pulled by a horizontal force applied at one edge and it always remains horizontal. When the disc is about to start moving, its top horizontal force will
A semi-circular disc rests on a horizontal surface with its top flat surface horizontal and circular portion touching down. The coefficient of friction between semi-cricular disc and horizontal surface is i. This disc is to be pulled by a horizontal force applied at one edge and it always remains horizontal. When the disc is about to start moving, its top horizontal force will
Why plate girder is preferred over truss girder?
Mrs. Lavanya took a cab to meet her three friends at a park. They were waiting for her outside the park when she pulled up in the car. She was so excited to see her friends that she left her hand purse in the cab. As the cab pulled away, she and her friends tock notice of the license plate number so that, they would be able to identify the car when they called the cab company. 1. The four women seem to agree that the plate starts out with the letter A. 2. Three of them agree that the plate ends with 15X. 3. Three of then think that the second letter is Z, and a different three think that the third letter is M. The four license plate numbers below represent what each of the four women thinks she saw. Which one is most likely the license plate number of the cab?