Stress strain curve of high tensile steel

A Has a definite yield point
B Does not show definite yield point but yield point is defined by 0.1% proof stress
C Does not show definite yield point but yield point is defined by 0.2% proof stress
D Does not show definite yield point but yield point is defined by 2% proof stress

Correct Answer: Does not show definite yield point but yield point is defined by 0.2% proof stress

Bissoy MCQ
#Civil Engineering #Concrete Technology And Design Of Concrete Structures

Related Questions

A cylinderical rod subjected to a tensile strain within the elastic limit undergoes a volume change. If the volume strain is equal to half the tensile strain, then the Poisson's ratio of the rod is
A 0
B 0.33
C 0.44
D 0.25
In a tensile test on mild steel specimen, the breaking stress as compared to ultimate tensile stress is
A More
B Less
C Same
D More/less depending on composition
The design stress, which is more than the damaging stress, is the least unit stress that will render a member unfit for service before the end of its normal life. The design stress factor or factor of safety indicates the margin between design stress and the __________ stress.
A Working
B Damaging
C Allowable
D None of these
In a tensile test, when the material is stressed beyond elastic limit, the tensile strain __________ as compared to the stress.
A Decreases slowly
B Increases slowly
C Decreases more quickly
D Increases more quickly
Every direct stress is always accompanied by a strain in its own direction and an opposite kind of strain in every direction, at right angles to it. Such a strain is known as
A Linear strain
B Lateral strain
C Volumetric strain
D Shear strain
The ultimate tensile strength of low carbon steel by working at a high strain rate will
A Decrease
B Increase
C Remain constant
D First increase and then decrease
The allowable tensile stress in structural mild steel plates for steel tank is assumed as
A 95.0 MPa on net area
B 105.5 MPa on net area
C 105.5 MPa on gross area
D 150.0 MPa on gross area
The allowable static stress for steel gears is approximately __________ of the ultimate tensile stress.
A One-fourth
B One-third
C One-half
D Double
The ultimate tensile stress for mild steel is __________ the ultimate compressive stress.
A Equal to
B Less than
C More than
D None of these
The ultimate tensile stress of mild steel compared to ultimate compressive stress is
A Same
B More
C Less
D Unpredictable

Next steps