Bissoy.com
Doctors Medicines MCQs Q&A

If the permissible stress in steel in tension is 140 N/mm2, then the depth of neutral axis for a singly reinforced rectangular balanced section will be

If the permissible stress in steel in tension is 140 N/mm2, then the depth of neutral axis for a singly reinforced rectangular balanced section will be Correct Answer 0.40 d

Related Questions

From an alloy, two specimens are machined and tested separately under tension and compression. The engineering stress-strain curves as well as the true stress-true strain curves for tension and compression are plotted in the same diagram. Identify the correct statements:
P. The engineering stress-strain curves in tension and compression are identical.
Q. The true stress-true strain curve in compression is lower than the true stresstrue strain curve in tension due to Bauschinger effect.
R. The true stress-true strain curve in tension is above the corresponding engineering stress-strain, curve.
S. The true stress-true strain curve in tension and compression are identical.
A singly reinforced beam has breadth b, effective depth d, depth of neutral axis n and critical neutral axis n?. If fc and ft are permissible compressive and tensile stresses, the moment to resistance of the beam, is
A singly reinforced beam has breadth b, effective depth d, depth of neutral axis n and critical neutral axis n1. If fc and ft are permissible compressive and tensile stresses, the moment to resistance of the beam, is
If the depth of neutral axis for a singly reinforced rectangular section is represented by kd in working stress design, then the value of k for balanced section
A singly reinforced concrete beam of 25 cm width and 70 cm effective depth is provided with 18.75 cm2 steel. If the modular ratio (m) is 15, the depth of the neutral axis, is
Consider the following statements regarding stress in beam : 1. If a member is subjected to equal and opposite couples acting in the same longitudinal planes, the member is said to be in pure bending. 2. The internal stresses developed in the beam are known as flexural stresses. 3. There is an intermediate surface known as neutral surface, at which the stress is zero. 4. An axis obtained by intersection of the neutral surface and a cross-section is known as neutral axis. Which of the above statements are correct ? 
If d and n are the effective depth and depth of the neutral axis respectively of a singly reinforced beam, the lever arm of the beam, is
In a singly reinforced beam, if the permissible stress in concrete reaches earlier than that in steel, the beam section is called
Tresca or maximum-shear stress criteria assumes that yielding occurs when the maximum shear stress reaches a value of the shear stress in the uniaxial tension test. Assume the principal stress being σ1, σ2, σ3 where σ1 is largest, and σ3 is the smallest principal stresses. Find the value of minimum shear stress to cause yielding, given that yield stress in tension is equal to σo?
If a rectangular under–reinforced section is subjected to bending moment equal to its moment carrying capacity and the stress in steel and extreme compression fiber of concrete at this moment are σs and σc respectively then which of the following is correct? Where, fy and fc are the permissible stresses in steel and concrete respectively.