Bissoy.com
Doctors Medicines MCQs Q&A

An R.C.C. beam of 25 cm width and 50 cm effective depth has a clear span of 6 meters and carries a U.D.L. of 3000 kg/m inclusive of its self weight. If the lever arm constant for the section is 0.865, the maximum intensity of shear stress, is

An R.C.C. beam of 25 cm width and 50 cm effective depth has a clear span of 6 meters and carries a U.D.L. of 3000 kg/m inclusive of its self weight. If the lever arm constant for the section is 0.865, the maximum intensity of shear stress, is Correct Answer 8.3 kg/cm<sup>2</sup>

Related Questions

An R.C.C beam of 25 cm width has a clear span of 5 metres and carries a U.D.L. of 2000 kg/m inclusive of its self weight. If the lever arm of the section is 45 cm., the beam is
Consider the following statements with regards to the shear force diagram for the beam ABCD: 1. The beam ABCD is an overhanging beam having supports at A and D only. 2. The beam carries a point load of 20 kN at C. 3. The beam carries a concentrated load of 10 kN at the end B. 4. The beam is an overhanging beam having supports at C and D only. 5. The beam carries a uniformly distributed load of 70 kN over the left hand portion AC only. Which of the above statements are correct?
A simply supported beam 6 m long and of effective depth 50 cm, carries a uniformly distributed load 2400 kg/m including its self weight. If the lever arm factor is 0.85 and permissible tensile stress of steel is 1400 kg/cm2, the area of steel required, is
Tresca or maximum-shear stress criteria assumes that yielding occurs when the maximum shear stress reaches a value of the shear stress in the uniaxial tension test. Assume the principal stress being σ1, σ2, σ3 where σ1 is largest, and σ3 is the smallest principal stresses. Find the value of minimum shear stress to cause yielding, given that yield stress in tension is equal to σo?
An R.C.C. beam of 6 m span is 30 cm wide and has a lever arm of 55 cm. If it carries a U.D.L. of 12 t per m and allowable shear stress is 5 kg/cm2, the beam
What is the condition for a tree to be weight balanced. where a is factor and n is a node? >= a*weight and weight >= a*weight. b) weight >= a*weight and weight >= a*weight. c) weight >= a*weight and weight >= a*weight. d) weight is a non zero
Calculate the maximum deflection of a cantilever beam with udl on entire span of 3m the intensity of you udl be 25 kN/m. Take EI as 4000 kN/m2.
A simply supported beam of span “x” meters carries a udl of “w” per unit length over the entire span, the maximum bending moment occurs at _____
In a ring beam subjected to uniformly distributed load
i) shear force at mid span is zero
ii) shear force at mid span is maximum
iii) torsion at mid span is zero
iv) torsion at mid span is maximum
The correct answer is
A reinforced concrete cantilever beam is 3.6 m long, 25 cm wide and has its lever arm 40 cm. It carries a load of 1200 kg at its free end and vertical stirrups can carry 1800 kg. Assuming concrete to carry one-third of the diagonal tension and ignoring the weight of the beam, the number of shear stirrups required, is