Related Questions

In a single point tool, the angle between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base, is known as
A Side relief angle
B End relief angle
C Back rake angle
D Side rake angle
The angle made by the face of the tool and the plane parallel to the base of cutting tool is called
A Rake angle
B Cutting angle
C Clearance angle
D Lip angle
Side rake angle of a single point cutting tool is the angle
A By which the face of the tool is inclined towards back
B By which the face of the tool is inclined sideways
C Between the surface of the flank immediately below the point and a plane at right angles to the centre line of the point of the tool
D Between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base
The rake angle of a single point cutting tool corresponds to _________ of a twist drill.
A Lip clearance angle
B Helix angle
C Point angle
D Chisel edge angle
Point A is 10 miles West of Point B. Point b is 30 miles North of pint C. Point C is 20 miles East of Point D. What is the distance (in miles) between Point A and Point D?
A 1010
B 1020
C 2010
D 3010
Point A is 10 km west of point B. Point B is 30 km north of point C. Point C is 20 km east of point D. What is the distance between point A and D?
A 1020Km
B 1010Km
C 2010Km
D 3010Km
Side relief angle of a single point tool is the angle
A By which the face of the tool is inclined towards back
B By which the face of the tool is inclined sideways
C Between the surface of the flank immediately below the point and a plane at right angles to the centre line of the point of tool
D Between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base
As the cutting speed increases, the tool cutting forces
A Remain constant
B Increases
C Decreases
D First increases and then decreases
In oblique cutting system, the cutting edge of the tool
A May clear the width of the workpiece
B May or may not clear the width of the workpiece
C May not clear the width of the workpiece
D Should always clear the width of the workpiece
In oblique cutting of metals, the cutting edge of the tool is
A Perpendicular to the workpiece
B Perpendicular to the direction of tool travel
C Parallel to the direction of tool travel
D Inclined at an angle less than 90° to the direction of tool travel

Next steps