Related Questions

In a compound steam engine, the first stage of expansion is carried out in a high pressure cylinder whereas the last expansion is completed in low pressure cylinder. The diameter of high pressure cylinder is _________ the low pressure cylinder.
A Equal to
B Less than
C More than
D None of these
In Meyer's expansion valve, the expansion valve is driven by an eccentric having an angle of advance from
A 50° - 60°
B 60° - 70°
C 70° - 80°
D 80° - 90°
For the same terminal conditions and valve size, the pressure drop in a fully opened globe valve as compared to that in a gate valve is
A More
B Less
C Equal
D Either A or B; depends on the viscosity of the fluid
In a vapour compression system, the condition of refrigerant before entering the expansion or throttle valve is
A High pressure saturated liquid
B Wet vapour
C Very wet vapour
D Dry vapour
In Meyer's expansion valve, the main valve is driven by an eccentric having an angle of advance from
A 10° - 15°
B 15° - 25°
C 25° - 30°
D 30° - 40°
A dilute aqueous solution is to be concentrated in an evaporator system. High pressure steam is available. Multiple effect evaporator system is employed, because
A Total heat transfer area of all the effects is -less than that in a single effect evaporator system
B Total amount of vapor produced per Kg of feed steam in a multiple effect system is much higher than in a single effect
C Boiling point elevation in a single effect system is much higher than that in any effect in a multieffect system
D Heat transfer co-efficient in a single effect is much lower than that in any effect in a multieffect system
The thermostatic expansion valve operates on the changes in the
A Degree of superheat at exit from the evaporator
B Temperature of the evaporator
C Pressure in the evaporator
D None of the above
The mixing vat in a factory receives liquid ingredients through six separate value--- labeled R.S.T.U,Y and Z -- each of which has exactly two settings: open and closed.The mixing vat operator must ensure that each valve is set open or closed according to the following conditions: If T is open, both S and Z must be closed, R and Z cannot both be closed at the same time; If Y is closed, Z must also be closed;S and U cannot both be open at the same time. Which of the following, if given to the mixing vat operator as an instruction, would not determine the setting of any other valve ?
A S must be open
B T must be open
C U must be open
For the same heat transfer area and the terminal conditions, the ratio of the capacities of a single effect evaporator to a triple effect evaporator is
A 3
B 0.33
C 1
D 1.33
The refrigeration effect in a dry evaporator compared to flooded evaporator in a similar plant is
A Same
B More
C Less
D More or less depending on ambient conditions

Next steps