Related Questions

This type of weld is the most common in structural steel fabrication:
A Fillet weld
B Beam weld
C Rivet weld
D Structural weld
Ten new television shows appeared during the month of September. Five of the shows were sitcoms, three were hour-long dramas, and two were news-magazine shows. By January, only seven of these new shows were still on the air. Five of the shows that remained were sitcoms.
A Only one of the news-magazine shows remained on the air.
B Only one of the hour-long dramas remained on the air.
C At least one of the shows that was cancelled was an hour-long drama.
D Television viewers prefer sitcoms over hour-long dramas.
In working drawings, these show all necessary information not given directly on the drawing with its dimensions and notes:
A Document strips
B Portable documents
C Formatting forms
D Title and record strips
The allowable tensile stress in structural mild steel plates for steel tank is assumed as
A 95.0 MPa on net area
B 105.5 MPa on net area
C 105.5 MPa on gross area
D 150.0 MPa on gross area
In U.S. structural and architectural drafting, all dimensions of this length are usually expressed in feet and inches:
A One inch or over
B One foot or over
C One yard or over
D One rod or over
In architectural drawing ________ are often used to illustrate and detail structural components.
A Foundation beam detail sections
B Wall sections
C Building sections
D All of the above
Forty tiles of dimensions 1 foot * 2 foot each are required to completely cover a floor. How many tiles of dimensions 2 foot * 4 foot each would be required to completely cover the same floor?
A 10
B 20
C 80
D 160
Architectural dimensioning standards allow for the placement of dimensions inside the floor plan. These inside dimensions locate interior __________.
A Door openings and walls
B Centers of cabinets
C Windows
D All of the above
Choose the correct set of dimensions of viscosity that are equivalent (where, F, M, L, T are dimensions for force, mass, length and time respectively).
A FL-2T, ML-1T-1
B FLT, ML-1T-1
C ML-1T-3, F-1L2T
D F-1L2T-1, MLT-3
One way to evenly space dimensions on a drawing is to use the __________.
A Dimension Space tool
B Linear tool
C Continue tool
D Baseline tool

Next steps