Related Questions

The design stress, which is more than the damaging stress, is the least unit stress that will render a member unfit for service before the end of its normal life. The design stress factor or factor of safety indicates the margin between design stress and the __________ stress.
A Working
B Damaging
C Allowable
D None of these
Every direct stress is always accompanied by a strain in its own direction and an opposite kind of strain in every direction, at right angles to it. Such a strain is known as
A Linear strain
B Lateral strain
C Volumetric strain
D Shear strain
The ratio of linear stress to linear strain is termed as the
A Modulus of elasticity
B Modulus of rigidity
C Bulk modulus
D None of these
A cylinderical rod subjected to a tensile strain within the elastic limit undergoes a volume change. If the volume strain is equal to half the tensile strain, then the Poisson's ratio of the rod is
A 0
B 0.33
C 0.44
D 0.25
The ratio of the lateral strain to the linear strain is called
A Modulus of elasticity
B Modulus of rigidity
C Bulk modulus
D Poisson's ratio
The ratio of lateral strain to the linear strain within elastic limit is known as
A Young's modulus
B Bulk modulus
C Modulus of rigidity
D Poisson's ratio
The ratio of lateral strain to linear strain is termed as the
A Poisson's ratio
B Bulk modulus
C Modulus of elasticity
D Shear modulus
The strain energy stored in a body due to shear stress, is (where $$\tau $$ = Shear stress, C = Shear modulus and V = Volume of the body)
A $$\frac{{\tau {\text{V}}}}{{2{\text{C}}}}$$
B $$\frac{{2{\text{C}}}}{{\tau {\text{V}}}}$$
C $$\frac{{{\tau ^2}{\text{V}}}}{{2{\text{C}}}}$$
D $$\frac{{2{\text{C}}}}{{{\tau ^2}{\text{V}}}}$$
Three elastic constants for a completely anisotropic elastic material which follows the Hooke's law are young's modulus, elastic limit stress and yield stress. Which of the following properties is most sensitive to increase in strain rate ?
A Tensile strength
B Elastic limit
C Proportional limit
D Yield strength
Young's modulus of elasticity of a material is the slope of the initial linear portion of the stress-strain curve. It decreases ap-preciablyby
A Alloying additions
B Heat treatment
C Cold work
D Increasing temperature

Next steps