Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Enhancement mode device acts as ____ switch, depletion mode acts as _____ switch.
You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy?
1. Switch (config-if) # ip access-group 10
2. Switch (config-if) # switchport port-security maximum 1
3. Switch (config) # access-list 10 permit ip host 1
4. Switch (config-if) # switchport port-security violation shutdown
5. Switch (config) # mac-address-table secure
The Transfer characteristic of the different types of MOSFETs is shown below, where ID is drain current and VGS is the Gate-Source voltage, the correct combination of MOSFET w.r.t to transfer characteristics is: Types of MOSFET (P) P – Channel Enhancement MOSFET (Q) P – Channel Depletion MOSFET (R) N – Channel Enhancement MOSFET (S) N – Channel Depletion MOSFET
Maximum voltage across enhancement mode device corresponds to minimum voltage across depletion mode device.
The depletion mode n-MOS differs from enhancement mode n-MOS in:
A diode had a transition capacitance of 1pF and depletion width of 1 µm. The capacitance changes to 10 pF when the depletion width changes. The final depletion width is __________
When device A has a cable that plugs into device B, and device B has a cable that plugs into device C and device C plugs into a port on the computer, this arrangement is called a _________
A depletion-type MOSFET can be operated in an enhancement mode where negative charges are induced into an n-type channel by applying
In direct coupled FET logic, both depletion and enhancement mode devices are used.
The depletion mode n-MOS as an active load is better than enhancement load n-MOS in: