Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

In comparing the operation of the half-controlled 2-pulse circuit with that of the fully-controlled circuit, which of the following statements are evident? 1. Since half the thyristors are replaced by diodes, a half-controlled converter costs less than a fully-controlled converter. 2. Due to the freewheeling action with a half-controlled bridge-circuit power factor is improved in half-controlled converters. 3. The AC supply current is more distorted due to its zero periods with the half-controlled circuit, compared to a fully-controlled bridge circuit. Select the correct answer using the code given below :
Consider the following statements in connection with deflection-type and null-type instruments: 1. Null-type instruments are more accurate than the deflection-type ones. 2. Null-type of instrument can be highly sensitive compared to a deflection-type instrument. 3. Under dynamic conditions, null-type instruments are less preferred to deflection-type instruments. 4. Response is faster in null-type instruments as compared to deflection-type instruments. Which of the above statements are correct?
When a closely-coiled helical spring of mean diameter (D) is subjected to an axial load (W), the deflection of the spring ($$\delta $$) is given by (where d = Diameter of spring wire, n = No. of turns of the spring and C = Modulus of rigidity for the spring material)
An open coiled helical compression spring 'A' of mean diameter 50 mm is subjected to an axial load ‘W’. Another spring 'B' of mean diameter 25 mm is similar to spring 'A' in all respects. The deflection of spring 'B' will be __________ as compared to spring 'A'.
A closely coiled helical spring is acted upon by an axial force. The maximum shear stress developed in the spring is $$\tau $$. The half of the length of the spring if cut off and the remaining spring is acted upon by the same axial force. The maximum shear stress in the spring in new condition will be
A block of mass M is attached to the lower end of a vertical spring. The spring is hung from a ceiling and has a force constant value k. The mass is released from rest with the spring initially unstretched. The maximum extension produced in the length of the spring will be:
An Op-Amp can be connected to provide 1. Voltage controlled current source 2. Current controlled voltage source 3. Current controlled current source Which of the above statements are correct?
When an open coiled helical compression spring is subjected to an axial compressive load, the maximum shear stress induced in the wire is (where D = Mean diameter of the spring coil, d = Diameter of the spring wire, K = Wahl's stress factor and W = Axial compressive load on the spring)
A moving coil instrument has a resistance of 70 Ω and gives full scale deflection of 100 scale divisions for a current of 1 mA. The instrument is connected in parallel with a shunt of 30 Ω resistance and this combination is then connected in series with a load and supply. Determine the current in the load when the instrument gives an indication of 80 scale divisions.
A Pickering governor is driving a gramophone. Each disc attached to the centre of a leaf spring has a mass of 20 g. The width of each spring is 5 mm and thickness of 0.125 mm. The effective length of each spring is 40 mm. The distance from the spindle axis to the centre of gravity of the mass when the governor is at rest, is 10 mm. Find the speed of the governor in rpm when the sleeve has risen to a height of 0.8 mm. (E = 210kN/mm2)