Bissoy.com
Doctors Medicines MCQs Q&A

A zero mean white Gaussian noise is passed through an ideal low pass filter of bandwidth 10 kHz. The output of the samples so obtained would be

A zero mean white Gaussian noise is passed through an ideal low pass filter of bandwidth 10 kHz. The output of the samples so obtained would be Correct Answer Statistically independent

Related Questions

A signal m(t) with bandwidth 500 Hz is first multiplied by a signal g(t). The resulting signal is passed through an ideal low pass filter with bandwidth 1 kHz. The output of the low pass filter would be :
A signal m(t) with bandwidth 500 Hz is first multiplied by a signal g(t) where
$$g\left( t \right) = \sum\limits_{k = - \infty }^\infty {{{\left( { - 1} \right)}^k}\delta \left( {t - 0.5 \times {{10}^{ - 4}}k} \right)} $$
The resulting signal is then passed through an ideal low pass filter with bandwidth 1 kHz. The output of the low pass filter would be
A signal containing only two frequency components (3 kHz and 6 kHz) is sampled at the rate of 8 kHz, and then passed through a low pass filter with a cut-off frequency of 8 kHz. The filter output
Consider a circuit as shown in figure The circuit is (1) Constant K low-pass filter (2) Constant K high-pass filter (3) The m-derived low-pass filter (4) The m-derived high-pass filter
A 1 kHz sinusoidal signal is ideally sampled at 1500 samples/sec and the sampled signal is passed through an ideal low-pass filter with cutoff frequency 800 Hz. The output signal has the frequency
A signal represented by x(t) =5cos 400πt is sampled at a rate 300 samples/sec. The resulting samples are passed through an ideal low pass filter of cut-off frequency 150 Hz. Which of the following will be contained in the output of the LPF?
White noise with power density No/2 = 6 microW/Hz is applied to an ideal filter of gain 1 and bandwidth W rad/s. If the output’s average noise power is 15 watts, the bandwidth W is
The low-pass active filter shown in the figure has a cut-off frequency of 2 kHz and a pass band gain of 1.5. The values of the resistors are
Electronics mcq question image
A 1.0 kHz signal is flat top sampled at the rate of 1800 samples/sec and the samples are applied to an ideal rectangular LPF with cut-off frequency of 1100 Hz, then the output of the filter contains
A 1.0 kHz signal is flat-top sampled at the rate of 1800 samples/sec and the samples are applied to an ideal rectangular LPF with cut-off frequency of 1100 Hz, then the output of the filter contains