Related Questions

A machine P can print out one lakh books in 8 hours. Machine Q can print the same number of books in 10 hours while machine R can print them in 12 hours. All the machines are started at 9 A.M.While machine P is stopped at 11 A.M. and remaining two machines completed the work. Approximately at what at what time will the work time (to print one lakh books) be finished?
A 11.30 Am
B 12 Noon
C 12.30 Pm
D 11.35 am
A small factory with 3 machines has a job of stamping out a number of pan covers. The newest machine can do the job is 3 days, another machine can do it in 4 days, and the third machine can do it in 6 days. How many days will the factory take to do the job using all the machine?
A 1.333
B 4.333
C 6
D 13
A machine P can paint one lakh books in 8 hours; machine Q can print the same number of books in 10 hours while machine R can print them in 12 hours. All the machines started operating at 9 A. M. while machine P is stopped at 11 A. M. and the reamaining two machines completed the work. Approximately at what time will the work (to print one lakh books) be finished?
A 11:30 A. M
B 12:00 noon
C 12:30 P. M.
D 1:00 P. M.
Three years ago, a machine was bought for Tk 1,00,000. The installation cost was Tk 20,000. The machine was depreciated in a straight line method at 20% per year. At the end of the 3rd year, the machine was sold for Tk 46,000. What is the gain/loss from sale of this machine?
A gain of Tk 2,000
B gain of Tk 6.000
C loss of Tk 2,000
D loss of Tk 6,000
E None of these
Which of the following is not the value the key property will hold if the key is a function key?
A F8
B F2
C F9
D Left
When assigning a shortcut key to a symbol, you should always try to select a key or key combination that is:
A Unassigned
B Located on the ten-key pad section of your keyboard.
C Assigned to another task.
D From the same font family as the symbol.
A taper key which fits half in the key way of the hub and half in the key way of shaft, is known as
A sunk key
B flat saddle key
C hollow saddle key
D tangent key
When the material of key and shaft is same, and the width of key is one-fourth of the diameter of shaft (d), then length of key will be
A 0.8 d
B 1.2 d
C 1.57 d
D 1.8 d
In a shipment of 120 machine parts, 5 percent were defective. In a shipment of 80 machine parts, 10 percent were defective. For the two shipments combined, what percent of the machine parts were defective?
A 6.5%
B 7%
C 7.5%
D 8.0%
In a shipment of 120 machine parts, 5 percent were defective. In a shipment of 80 machine parts, 10 percent were defective. For the two shipments combined, what percent of the machine parts were defective ?
A 6.5%
B 7.0%
C 7.5%
D 8.0%

Next steps