Which of the following would be a good starting point for troubleshooting if your router is not translating?

A Reboot.
B Call Cisco.
C Check your interfaces for the correct configuration.
D Run the <code class="args"><em>debug all</em></code> command.

Correct Answer: Check your interfaces for the correct configuration.

In order for NAT to provide translation services, you must have ip nat inside and ip nat outside configured on your router's interfaces.
Bissoy MCQ
#Networking #Network Address Translation

Related Questions

You need to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface of the router for this connection?
A Router (config-if) #encapsulation frame-relay q933a
B Router (config - if) #encapsulation frame-relay ansi
C Router (config - if) #encapsulation frame-relay ietf
D Router (config - if) #encapsulation frame-relay cisco
The corporate office sends you a new router to connect, but upon connecting the console cable, you see that there is already a configuration on the router. What should be done before a new configuration is entered in the router?
A RAM should be erased and the router restarted
B Flash should be erased and the router restarted
C NVRAM should be erased and the router restarted
D The new configuration should be entered and saved
You save the configuration on a router with the copy running-config startup-config command and reboot the router. The router, however, comes up with a blank configuration. What can the problem be?
A You didn
B NVRAM is corrupted.
C The configuration register setting is incorrect.
D The newly upgraded IOS is not compatible with the hardware of the router.
You are troubleshooting a connectivity problem in your corporate network and want to isolate the problem. You suspect that a router on the route to an unreachable network is at fault. What IOS user exec command should you issue?
A Router>ping
B Router>trace
C Router>show ip route
D Router>show interface
You need to find the broadcast address used on a LAN on your router. What command will you type into the router from user mode to find the broadcast address?
A show running-config
B show startup-config
C show interfaces
D show protocols
If routers in a single area are configured with the same priority value, what value does a router use for the OSPF Router ID in the absence of a loopback interface?
A The Lowest IP address of any physical interface
B The Highest IP address of any physical interface
C The Lowest IP address of any logical interface
D The Highest IP address of any logical interface
Your computer has a mirrored volume and you wish to now install the Recovery Console for future troubleshooting. How do you do this?
A Reinstall Windows, this can only be applied during the installation
B Break the mirror, run X:i386winnt32.exe /cmdcons Reestablish the mirror
C Run X:i386winnt32.exe / cmdcons
D Run the add and remove programs and add the recovery console
E None of above
Which of the following would be a logical first step in troubleshooting a PC?
A Check the computer CMOS
B Define the circumstances of the problem
C Call the vendor
D Define what applications are being used
E None of the above
Which would you do first when troubleshooting a faulty monitor?
A Check its connections to the computer and power source
B Use a meter to check the CRT and internal circuitry for continuity
C Power down the monitor, then turn it on again to see if that corrects the problem
D Power down the computer, then turn it on again to see if that corrects the problem
E None of the above
Point A is 10 miles West of Point B. Point b is 30 miles North of pint C. Point C is 20 miles East of Point D. What is the distance (in miles) between Point A and Point D?
A 1010
B 1020
C 2010
D 3010

Next steps