Related Questions

In this type of view, the cutting plane line indicates both the location of the cutting plane and the direction of sight:
A Removed section
B Revolved section
C Auxiliary section
D Partial section
In an exploded assembly drawing it is customary for the drafter to use a ________ line to illustrate how parts fit together.
A Phantom
B Hidden
C Dashed
D Center
A ________ section allows the drafter to create a Cutting Plane line which is not in a straight line across the part.
A Offset
B Half
C Whole
D Broken out
In a horizontal flat belt drive, it is customary to use
A Bottom side of belt as slack side
B Top side of belt as slack side
C Idler pulley
D None of the above
Plane P take off at 2:00 am and flies at a constants speed of Xmph. Plane Q takes off at 3:30 am and flies the same forte as plane p but travels at a constant X, how many hours after 3:30 am will plane Q overtake plan P?
A 1.5x/y +0.5
B 2
C 4
D 5
To insure that everyone understands what the electrical symbols represent it is customary to include a ________ on the electrical sheet.
A List
B Part number
C Electrical legend
D Electrical layer
Which key is used to obtain properties palette in AutoCAD?
A Control+1
B Control+2
C Control+3
D Control+4
Which type of coordinate system is used in AutoCAD?
A 2-Dimensional
B 3-Dimensional
C 1-Dimensional
D User dependent
The "snap" command feature in both AutoCAD and VersaCAD ensure that:
A template lines can be removed
B objects are entered at specific intervals.
C identified data are automatically segmented
D definable center markers are entered.
E None of the above
When lines intersect on a drawing at angles of this many degrees, it is customary not to dimension the angle:
A 360
B 180
C 90
D 45

Next steps