Related Questions

A PPI cathode-ray tube as used on a radar set
A Is used to check the percentage of modulation
B Indicates both the range and azimuth of a target
C Indicates only the range of a target
D Is used for receiver alignment
In most of the shell and tube heat exchangers, the tube pitch is generally __________ the tube diameter.
A Less than
B 1.25-1.50 times
C 2.5 times
D One-fourth of
For the same diameter and thickness of tube, a water tube boiler has ________ heating surface as compared to fire tube boiler.
A More
B Less
C Equal
D None of these
Minimum tube pitch recommended for shell and tube heat exchangers is about __________ times the outside diameter of the tube.
A 1.25
B 1.75
C 2.5
D 3.5
For the same diameter and thickness of tube, a water tube boiler compared to a fire tube boiler has
A More heating surface
B Less heating surface
C Equal heating surface
D Heating surface depends on other parameters
In a shell and tube heat exchanger, the tube side heat transfer co-efficient just at the entrance of the tube is
A Infinity
B Zero
C Same as average heat transfer co-efficient for tube side
D None of these
For the same heat load and mass flow rate in the tube side of a shell and tube heat exchanger, one may use multipass on the tube side, because it
A Decreases the pressure drop
B Decreases the outlet temperature of cooling medium
C Increases the overall heat transfer coefficient
D None of these
Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is
A Finned tube heat exchanger with air inside and steam outside
B Finned tube heat exchanger with air outside and steam inside
C Shell and tube heat exchanger with air inside tubes and steam on shell side
D Shell and tube heat exchanger with air on shell side and steam inside tubes
In which of the following evaporators, steam is fed inside the tube while the liquor is outside the tube?
A Long tube vertical evaporator
B Short tube vertical evaporator
C Horizontal tube evaporator
D None of these
In a shell and tube type heat exchanger, the floating tube bundle heat arrangement is used
A In low range of temperature differences
B In high range of temperature differences
C Because of its low cost
D To prevent corrosion of the tube bundles

Next steps