Related Questions

Which of the following TCP/IP protocol is used for remote terminal connection service?
A TELNET
B FTP
C RARP
D UDP
E None of the above
When two computers communicate with each other, they send information back and forth. If they are separated by a reasonable distance, they can send and receive the information through a direct cable connection which is called a null-modem connection. Presently what is the maximum distance in metres permitted in this null-modem connection?
A 80
B 100
C 30
D 150
E None of the above
What standard, protocol or language was generalized to become a standard protocol for sending messages of any type, using any protocol?
A SOAP
B SGML
C SQL
D ADO
Which connection is used to access the internet in a very remote location?
A Dial-up
B satellite
C cable
D DSL
Two buses start from a bus terminal with speed of 20 km/h at interval of 10 minutes. What si the speed of a man coming from the opposite direction towards the bus terminal if he meets thebuses at interval of 8 minutes?
A 3 km/h
B 4 km/h
C 5 km/h
D 7 km/h
Two buses start from a bus terminal with a speed of 20 km/h at interval of 10 minutes. What is the speed of a man coming from the opposite direction towards the bus terminal if he meets the buses at interval of 8 minutes?
A 3 km/h
B 4 km/h
C 5 km/h
D 7 km/h
When the emitter terminal of a UJT is open, the resistance between the base terminal is generally ___________.
A High
B Low
C Extremely low
D None of the above
When a UJT is turned ON, the resistance between emitter terminal and lower base terminal ___________
A Remains the same
B Is decreased
C Is increased
D None of the above
If ground is applied to the (+) terminal of an inverting OP-amp, the (–) terminal will
A Not need an input resistor
B Be virtual ground
C Have high reverse current
D Not invert the signal
You need to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface of the router for this connection?
A Router (config-if) #encapsulation frame-relay q933a
B Router (config - if) #encapsulation frame-relay ansi
C Router (config - if) #encapsulation frame-relay ietf
D Router (config - if) #encapsulation frame-relay cisco

Next steps