Related Questions

When installing an internal modem, all of the following IRQ's can be used except?
A 5
B 10
C 14
D All of the above
E None of the above
You want to install a new internal CD-ROM drive. You must first confirm that there will be no IRQ conflicts. How should you do this?
A Use Server Manager
B Use Windows NT Diagnostics
C Use the Devices option in Control Panel
D Use the Add/Remove Programs option in Control Panel
E None of the above
If you are looking for a job or plan to reenter the working world, you might find the job hunt a difficult task. if you rewrite the sentence begining with "Looking for a job or " the next word should be__
A finding
B being
C looking
D reentering
Whenever you have a hardware resource conflict, it will more likely be an IRQ conflict rather than an i/o conflict because:
A there are a lot more I/O addresses than IRQs.
B the BIOS sometimes has more of a problem controlling IRQs
C I/O addresses cannot conflict
D software tends to correct I/O conflicts
E software tends to mess up IRQs
A sound card typically uses which IRQ?
A 6
B 5
C 15
D 1
E it doesn't use an IRQ
What are the IRQ's for sound card?
A IRQ8
B IRQ4
C IRQ5
D IRQ7
E None of the above
You see the message "invalid media device" after installing a new hard drive. What do you do next?
A Format
B Fdisk
C Partition
D Add the OS
E None of the above
You have just installed a new internal PCI modem on you desktop. It will not dial out. what is the problem?
A The port speed is set too high
B the modem has not been set up in control panel properties
C the phone line is plugged into the line-in port on the modem card
D the phone line out of the wall is plugged into the phone port on the modem card
E None of the above
When installing a SCSI CD-ROM drive, you must set the CD-ROM SCSI adapter to:
A B0007
B An unused SCSI address
C The same address as the SCSI device before the CD-ROM
D SCSI ID=1
E None of the above
You are installing an IDE hard drive that will be your boot drive. Which is the correct order of steps that need to be followed?
A jumper properly, auto-detect(or configure manually) in CMOS, low level format, high level format, partition
B jumper properly, auto-detect(or configure manually) in CMOS, partition, high level format with / s switch
C jumper properly, partition, auto-detect(or configure manually in CMOS, high level format with /s switch
D jumper properly, auto-detect in CMOS, regular format
E jumper properly, partition, low level format, high level format

Next steps