Related Questions

A path for carrying signals between a source and a destination is know as
A Router
B Channel
C Link
D Block
A path carrying signals between a source and a destination is known as
A Pouter
B Cannel
C Link
D Block
A station in a network forwards incoming packets by placing them on its shortest output queue. What routing algorithm is being used?
A hot potato routing
B flooding
C static routing
D delta routing
E None of the above
When the addenda on pinion and wheel is such that the path of approach and path of recess are half of their maximum possible values, then the length of the path of contact is given by (where r = Pitch circle radius of pinion, R = Pitch circle radius of wheel and $$\varphi $$ = Pressure angle)
A $$\frac{{\left( {{{\text{r}}^2} + {{\text{R}}^2}} \right)\cos \varphi }}{2}$$
B $$\frac{{\left( {{{\text{r}}^2} + {{\text{R}}^2}} \right)\sin \varphi }}{2}$$
C $$\frac{{\left( {{\text{r}} + {\text{R}}} \right)\cos \varphi }}{2}$$
D $$\frac{{\left( {{\text{r}} + {\text{R}}} \right)\sin \varphi }}{2}$$
In covering a certain distance , the speeds of A and B are in the ratio of 3 : 4. A takes 30 minutes more than B to reach the destination. The time taken by A to reach the destination is :
A 1.0 hour
B 1.5 hours
C 2.0 hours
D 2.5 hours
when a truck travels at 60 miles per hour, it uses 30 percent more gasoline to travel andy distance than it does when it travels at 50 miles per hour. The truck can travel 20 miles on a gallon of gas if it is travelling at 50 miles per hour. The truck has only 10 gallons of gas and is 160 miles from its destination. It takes 20 minutes for the truck to stop for gas . How long will it take the truck to reach its final destination if it is driven at 60 miles per hour?
A 160 minutes
B 180 minutes
C 190 minutes
D 192 minutes
Two bikes start at he same time from two destination 200 km apart and traved towards each other. If they cross each other at a distance of 130 km from one of the destination, what is the ratio of their speeds?
A 17:13
B 7:3
C 1:3
D 2:3
If a switch receives a frame and the source MAC address is not in the MAC address table but the destination address is, what will the switch do with the frame?
A Discard it and send an error message back to the originating host
B Flood the network with the frame
C Add the source address and port to the MAC address table and forward the frame out the destination port
D Add the destination to the MAC address table and then forward the frame
If your routing table has a static, a RIP, and an IGRP route to the same network, which route will be used to route packets by default?
A Any available route
B RIP route
C Static route
D IGRP route
E They will all load-balance.
Which of the following condition is used to transmit two packets over a medium at the same time?
A Contention
B Collision
C Synchronous
D Asynchronous
E None of the above

Next steps