If your routing table has a static, a RIP, and an IGRP route to the same network, which route will be used to route packets by default?

A Any available route
B RIP route
C Static route
D IGRP route
E They will all load-balance.

Correct Answer: Static route

Static routes have an administrative distance of 1 by default. Unless you change this, a static route will always be used over any other found route. IGRP has an administrative distance of 100, and RIP has an administrative distance of 120, by default.
Bissoy MCQ
#Networking #IP Routing

Related Questions

Two connected routers are configured with RIP routing. What will be the result when a router receives a routing update that contains a higher-cost path to a network already in its routing table?
A The updated information will be added to the existing routing table Debug IP rip
B The update will be ignored and no further action will occur Debug IP route
C The updated information will replace the existing routing table entry
D The existing routing table entry will be deleted from the routing table and all routers will exchange routing updates to reach convergence
What command is used to stop RIP routing updates from exiting out an interface but still allow the interface to receive RIP route updates?
A Router (config-if) # no routing
B Router (config-if) # passive-interface
C Router (config-router) # passive-interface s0
D Router (config-router) # no routing updates
A station in a network forwards incoming packets by placing them on its shortest output queue. What routing algorithm is being used?
A hot potato routing
B flooding
C static routing
D delta routing
E None of the above
Which command displays RIP routing updates?
A Show IP route
B Debug IP rip
C Show protocols
D Debug IP route
When they had a meeting seven company executives __ T, U, V, W, X, Y and Z ___ sit at a rectangular table .Three executives sit along one side of the table , and three sit along the other side, each directly opposite one of the other three. The seventh sits at the head of the table . There is no seat at the foot of the table . Ualways sits in one of te two seats farthest from the head of the table. Y and V always sit next to each other .V never sits next to Z . If Z does not sit at the head of the table, W sits there. If W sits directly opposite T, X must sit next to which of the following excutives?
A T
B U
C V
D Z
Six arms negotiators -- M,O,P,R,S and T-- are to be seated at a round table to discuss disarmament. There are exactly six chairs around the table. Each negotiator sits facing the center of the table and is directly opposite a negotiators across the table.The seating arrangement is subject to the following restrictions : T cannot sit next to P;S cannot sit next to M;R must sit next to M. Which of the following is an acceptable sequence of negotiators around the table ?
A M,S,R,T,P,O
B M,S,T,P,R,O
C T,O,P,S,M,R
D T,R,M,P,S,O
Six arms negotiators -- M,O,P,R,S and T-- are to be seated at a round table to discuss disarmament. There are exactly six chairs around the table. Each negotiator sits facing the center of the table and is directly opposite a negotiators across the table.The seating arrangement is subject to the following restrictions : T cannot sit next to P;S cannot sit next to M;R must sit next to M. If T sits directly across the table from O, who must sit on the other side of P?
A M and O
B M and S
C O and R
D O and S
You are troubleshooting a connectivity problem in your corporate network and want to isolate the problem. You suspect that a router on the route to an unreachable network is at fault. What IOS user exec command should you issue?
A Router>ping
B Router>trace
C Router>show ip route
D Router>show interface
You are adding a new server to your network. The network uses TCP/IP. The new server will provide users with dial-up access to network resources. The data link communications protocol you choose for dial-up access must allow you to provide secure authentication. Which protocol should you choose?
A PPP
B DLC
C In the System option in Control Panel, select the setting that allows users to log on locally
D In the System option in Control Panel, set the user environment variables to allow Maria to log on locally
E None of the above
Which layer is used to handle the network addressing and routing?
A Network Access Layer
B Internet Layer
C Transport Layer
D Presentation Layer

Next steps