Bissoy.com
Doctors Medicines MCQs Q&A

Helical gear is used for transmitting the power between two ___________

Helical gear is used for transmitting the power between two ___________ Correct Answer Parallel shafts

Helical gear is used for transmitting power between parallel shafts and the teeth are inclined to the axis of the wheel which helps in meshing more than two teeth at a time.

Related Questions

A gear train consist of spur gear as shown. Gear A receives 4kW of power at 750rpm through its shaft and rotates in CW direction. A gear train consist of spur gear as shown. Gear A receives 4kW of power at 750rpm through its shaft and rotates in CW direction. Calculate the torque on the gear C if number of teeth on gear A, B and C are 40, 70 and 30.
A planetary gear train is shown in the figure. Number of teeth on the sun gear A, planet gear B and fixed ring gear D are given by 30, 70 and 140 respectively. Module is taken as 5mm. A pair of spur gears consist of 25 teeth pinion meshing with a 115 teeth gear. The module is 5mm. Calculate the gear ratio.
Following is the data for transmission system of a Gear box reduction ratios.
1st gear - 4.3 : 1
2nd gear - 3.00 : 1
3rd gear - 2.71 : 1
4th gear - 1 : 1
Final drive reduction is 5.0 : 1
The overall reduction when the vehicle is driven in 2nd gear is
Consider two shafts connected with two gears as per the following options: 1. One on each shaft 2. Through an intermediate gear mounted on an intermediate shaft, and every shaft having one gear only 3. Through an intermediate gear mounted on an intermediate shaft, with the intermediate shaft having two gears, whereas the other shafts have one gear each Which of the above represent(s) a simple gear train?
A gear train consist of spur gear as shown. Gear A receives 4kW of power at 750rpm through its shaft and rotates in CW direction. Calculate the tangential gear tooth force. Module of the gear is 5mm.
A planetary gear train is shown in the figure. Number of teeth on the sun gear A, planet gear B and fixed ring gear D are given by 30, 70 and 140 respectively. Module is taken as 5mm. Calculate the tangential component of gear tooth force.
The velocity ratio between pinion and gear in a gear drive is 2.3, the module of teeth is 2.0 mm and sum of number of teeth on pinion and gear is 99. What is the centre distance between pinion and the gear?
The load on a gear tooth is 50 kN. If the gear is transmitting a torque of 6000 Nm, the diameter of the gear is approximately
A gear train consist of spur gear as shown. Gear A receives 4kW of power at 750rpm through its shaft and rotates in CW direction. Calculate the torque on the gear A.
A gear train consist of spur gear as shown. Gear A receives 4kW of power at 750rpm through its shaft and rotates in CW direction. Calculate the torque on the gear B.