Bissoy.com
Doctors Medicines MCQs Q&A

Chain and sprocket drive is used, where _____________

Chain and sprocket drive is used, where _____________ Correct Answer Two shafts are at short distance

Chain and sprocket are used to transmit motion and power where two parallel shafts are spaced apart at short distances. It is a positive drive.

Related Questions

The relation between the pitch of the chain (p) and pitch circle diameter of the sprocket (D) is given by (where T = Number of teeth on the sprocket)
Which one of the following four addresses is NOT EXACTLY same as the one given below? Cabramatta 360 Elizabeth Drive, 2170 Mount Pritchard, Australia (i) Cabramatta 360 Elizabeth Drive, 2170 Mount Pritchard, Australia (ii) Cabramatta 360 Elizabeth Drive, 2170 Mount Pritchard, Australia (iii) Cabrematta 360 Elizabeth Drive, 2170 Mount Pritchard, Australia (iv) Cabramatta 360 Elizabeth Drive, 2170 Mount Pritchard, Australia
Which one of the following four addresses is NOT EXACTLY same as the one given below?  Kedrick Shaw 72 Glenwood Drive, Thornton, NSW 2322, Australia (i)  Kedrick Shaw  72 Glenwood Drive,  Thornton, NSW 2322, Australia (ii) Kedrick Shaw  72 Glenwood Drive,  Thornton, NSW 2322, Australia (iii) Kedrick Shaw  72 Glenwood Drive,  Thornton, NSW 2322, Australia (iv) Kedrick Shaw  72 Glemwood Drive,  Thornton, NSW 2322, Australia
Driving and driven pulleys are rotating at 1000rpm and 500rpm. If number of teeth on driving sprocket are 20, find number of teeth in the driven sprocket.
A gear meshes with another gear and a sprocket meshes with another sprocket.
Chain and sprocket drive is preferred, when two parallel shafts are placed at a distance of _______
The driving sprocket has 19 teeth and rotates at 1100rpm. The pitch of the chain is 18mm. Calculate the velocity of the chain.
Lesser is the number of the teeth on sprocket, the variation in the speed of chain drive is
The length of a survey line was measured with a 20 m chain and was found to be equal to 1200 m. If the length again measured with 25 m chain it is 1212 m. On comparing the 20 m chain with the test gauge, it was found to be 1 decimeter too long. Find the actual length of 25 m chain used.
You are about to install a second IDE hard drive in a PC that has only one IDE adapter. Your first hard drive will still be the boot drive. How should the second drive be configured?