Bissoy.com
Doctors Medicines MCQs Q&A

In power tiller for transmitting the power from engine to the main clutch the belt used is __________

In power tiller for transmitting the power from engine to the main clutch the belt used is __________ Correct Answer V-belt

A V-belt is the rubber belt that drives the alternator, air conditioning compressor, power steering pump and water pump. It’s called a V-belt because of its “V” shaped cross-section. All belts wear out over time and need to be replaced.

Related Questions

Consider the following statements regarding clutches 1. Dry clutch has higher coefficient of friction compared to wet clutch 2. The torque capacity of wet clutch is high compared to dry clutch. 3. The engagement in a dry clutch is smoother than in case of wet clutch. Which of the above statements is/are correct ?
When the belt is transmitting maximum power, the belt speed should be (Where, m = mass of belt per meter (kg/m) and Pmax = maximum permissible tension in belt (N))
When the belt is transmitting maximum power, the belt speed should be
(Where, m = mass of belt per meter (kg/m) and Pmax = maximum permissible tension in belt (N))
Consider the following statements regarding V-belt drive : 1. The groove angle of the sleeve is less than the belt section angle 2. The efficiency of a V-belt drive is higher than that of a flat belt drive 3. The groove angle is so made that the belt gets wedged in the groove  Which of the above statements are correct ? 
A centrifugal clutch has four shoes. When the clutch is at rest, each shoe is pulled against a stop by a spring so that it leaves a radial clearance of 10 mm between the shoe and the rim. The pull exerted by the spring is then 700 N. The mass centre of the shoe is 150 mm from the axis of the clutch. If the internal diameter of the rim is 500 mm, the mass of each shoe is 6 kg, the stiffness of each spring is 75 N/mm and the coefficient of friction between the shoe and the rim is 0.35; find the power transmitted by the clutch at 400 r.p.m.
A centrifugal clutch has four shoes. When the clutch is at rest, each shoe is pulled against a stop by a spring so that it leaves a radial clearance of 7.5 mm between the shoe and the rim. The pull exerted by the spring is then 600 N. The mass centre of the shoe is 120 mm from the axis of the clutch. If the internal diameter of the rim is 350 mm, the mass of each shoe is 5 kg, the stiffness of each spring is 60 N/mm and the coefficient of friction between the shoe and the rim is 0.2; find the speed of the centrifugal clutch, if the power transmitted is 40.168 kW.
The efficiency of flat belt drive is 35%. If all the parameters are same and flat belt is replaced by V belt, than the efficiency of V belt will be?
A bucket wheel excavator with 20 buckets of capacity 0.5 m3 each, rotates at 5 rev/min. The bucket fill factor is 80%. The excavator loads on to 1200 mm wide belt conveyor. The cross-section area (m2) of the material on the belt is 0.1B2, where B is the belt width in m. The minimum speed of the belt in m/s to avoid spillage of material is
The ratio of belt tensions $$\frac{{{{\text{p}}_1}}}{{{{\text{p}}_2}}}$$ considering centrifugal force in flat belt is given by where,
m = mass of belt per meter (kg/m)
v = belt velocity (m/s)
f = coefficient of friction
$$\alpha $$ = angle of wrap (radians)
Which of the following belts are associated with seismic activity?
1. Circum-Pacific Belt
2. Circum-Atlantic Belt
3. Mid-Continental Belt
4. Mid-Atlantic Belt