Bissoy.com
Doctors Medicines MCQs Q&A

_____________ is the amount of moisture a material will absorb relative to ambient temperature and humidity conditions.

_____________ is the amount of moisture a material will absorb relative to ambient temperature and humidity conditions. Correct Answer Hygroscopic action

Hygroscopic action is the amount of moisture a material will absorb with respect to the temperature and humidity conditions. Due to hydroscopic action, the sample will continuously increase/ decrease in weight.

Related Questions

High relative humidity decreases the evaporative process and as the temperature is increased, the relative humidity decreases. The comfort range for human body is the ambient temperature of 22 to 27°C with relative humidity ranging from __________ percent.
Consider the following statements and choose the correct answer:
1. A direct proportionality exists between vapour pressure and the concentration of water vapour in the atmosphere
2. Relative humidity is an expression of the ratio of the actual vapour pressure of the atmosphere when saturated at the same temperature
3. A rise or fall in temperature with no change in vapour pressure will cause a drop or rise, respectively, in relative humidity
4. A rise or fall in vapour pressure with no change in temperature will be accompanied by a rise or fall, respectively, in relative humidity
Consider the following statements with regard to atmospheric humidity: 1. Absolute humidity is the amount of water vapour per unit volume. 2. Hygrometer is used to measure relative humidity. 3. Dew point is the temperature at which the relative humidity is 75%. Which of the above statements are correct?
Match the items in column 1 and column 2 and choose the correct combination. Column 1 Column 2 A - Resilience 1 – Ability of the material to return to the original shape when load is removed B – Fatigue 2 – Capacity of a material to absorb energy elastically C – Stiffness 3 – Ability of material to absorb a certain amount of energy without failure D - Elasticity 4 – Resistance of the material to elastic deformation   5 – Failure of material at loads less than that at normal conditions  
In a laboratory test run, the rate of drying was found to be 0.5 × 10-3 kg/m2.s, when the moisture content reduced from 0.4 to 0.1 on dry basis. The critical moisture content of the material is 0.08 on a dry basis. A tray dryer is used to dry 100 kg (dry basis) of the same material under identical conditions. The surface area of the material is 0.04 m2/kg of dry solid. The time required (in seconds) to reduce the moisture content of the solids from 0.3 to 0.2 (dry basis) is
In the question below are given six statements followed by four conclusions numbered I, II, III and IV. You have to take the given statements to be true even if they seem to be at variance with commonly known facts. Read all the conclusions and then decide which of the given conclusions logically follows from the given statements disregarding commonly known facts. Statements: All Petrol are Gasoline. No petrol is Water. Some Water are Gas. Some Moisture are Gas. All Gasoline are Fire No Moisture is Fire Conclusions: I. Some Moisture are Gasoline. II. Some Water are Moisture. III. Some Gasoline are Gas. IV. Some Petrol are Moisture.
Humidity chart is useful for the solution of problems concerning condensation, vaporisation and air conditioning. At a given dry bulb temperature, value of humidity obtained from the humidity chart directly, is in terms of __________ humidity.
If ouside air is to be conditioned from 60% relative humidity and 40 °C dry bulb temperature to 50% relative humidity and 24 °C dry bulb temperature, which psychromatic process would be required?
It is desired to condition the outside air from 70% relative humidity and 45°C dry bulb temperature to 50% relative humidity and 25°C dry bulb temperature (room condition). The practical arrangement will be
Consider the following statements: 1. The relative humidity of air does not change with temperature as long as specific humidity remains constant. 2. Dew-point temperature is the temperature at which condensation begins when air is cooled at constant volume. 3. Saturated air passing over a water surface does not cause change of air temperature. 4. For saturated air, dry-bulb, wet-bulb and dew-point temperatures are identical. Which of the above statements are correct?