The moisture content of the paper sheet after passing through the rotary presses is _______

The moisture content of the paper sheet after passing through the rotary presses is _______ Correct Answer 60%–70%

Rotary presses (which may have solid or perforated rollers, often with internal suction) receive the sheets on continuous felts, which act as conveyers and porous receptors of water. On leaving the press, the moisture content is typically 60%–70%, again depending on type.
Bissoy MCQ

Related Questions

It takes 6 hours to dry a wet solid from 50% moisture content to the critical moisture content of 15%. How much longer it will take to dry the solid to 10% moisture content, under the same drying conditions? (The equilibrium moisture content of the solid is 5%).
A solid is being dried in the linear drying rate regime from moisture content Xo to XF. The drying rate is zero at X = 0 and the critical moisture content is the same as the initial moisture Xo. The drying time for M = (Ls/ARc) is (where, L = total mass of dry solid, A = total surface area for drying Rc = Constant maximum drying rate per unit area X = moisture content (in mass of water/mass of dry solids)
200 kg of solids (on dry basis) is subjected to a drying process for a period of 5000 seconds. The drying occurs in the constant rate period with the drying rate as, Nc = 0.5 × 10-3 kg/m2.s. The initial moisture content of the solid is 0.2 kg moisture/kg dry solid. The interfacial area available for drying is 4 m2/1000 kg of dry solid. The moisture content at the end of the drying period is (in kg moisture/kg dry solid)
Shoe presses or other special presses to promote good fiber bonding and decrement in web moisture contents.
Find the initial moisture content for the batch process if the final moisture content is 25% (dry basis) and the constant moisture content is 40%. (Includes constant and falling rate period)
Find the final moisture content for the batch process if the initial moisture content is 75% (dry basis) and the constant moisture content is 40%. (Includes constant and falling rate period)
The x- axis is the moisture content on dry basis. The y-axis is the equilibrium moisture content. Which of the following shows Bound moisture content?
A dryer is used for drying pears which has initial moisture content of 70 % (wet basis) and final moisture content of 5 % (wet basis). An experimental drying curve for the product indicates that the critical moisture content is 25 % (wet basis) and the time for constant drying is 5 min. Can you estimate the total drying time for product?
In a laboratory test run, the rate of drying was found to be 0.5 × 10-3 kg/m2.s, when the moisture content reduced from 0.4 to 0.1 on dry basis. The critical moisture content of the material is 0.08 on a dry basis. A tray dryer is used to dry 100 kg (dry basis) of the same material under identical conditions. The surface area of the material is 0.04 m2/kg of dry solid. The time required (in seconds) to reduce the moisture content of the solids from 0.3 to 0.2 (dry basis) is
The press felt normally runs over the paper web going through a press section. It’s designed to adsorb H2O squeezed out of the sheet and to support the sheet throughout the presses.