Bissoy.com
Doctors Medicines MCQs Q&A

What is convective mass transfer?

What is convective mass transfer? Correct Answer Combination of molecular diffusion and eddy diffusion

The convective mass transfer is the combination of molecular diffusion and the eddy diffusion. The mass transfer in convective mode is due to the movement of fluid in bulk, for example, flow of water will transport the molecules that are present or dissolved in the water.

Related Questions

A stream of air at 100 kPa pressure and 300 K is flowing on the top surface of a thin flat sheet of solid naphthalene of length 0.2 m with a velocity of 20 m/sec. The other data are: Mass diffusivity of naphthalene vapor in air = 6 * 10 –6 m2/sec Kinematic viscosity of air = 1.5 * 10 –5 m2.sc Concentration of naphthalene at the air-solid naphthalene interface = 1 * 10 – 5 kmol/m3 Calculate the overage mass transfer coefficient over the flat plate. Note: For heat transfer over a flat plate, convective heat transfer coefficient for laminar flow can be calculated by the equation. Nu = 0.664 ReL1/2 Pr1/3 you may use analogy between mass and heat transfer.
What is the monoisotopic and average mass of valine? Given data: Mass of the most abundant isotope of Carbon (C°)=12.0000, Mass of most abundant isotope of Hydrogen (H°)=1.0078, Mass of most abundant isotope of Oxygen (O°)=15.9949, Mass of most abundant isotope of Nitrogen (N°)=14.0031, The average mass of Carbon (C)=12.011, The average mass of Hydrogen (H)=1.008, The average mass of Oxygen (O)=15.999, The average mass of Nitrogen (N)=14.007.
For a laminar flow of fluid in a circular tube, 'h₁' is the convective heat transfer co-efficient at velocity 'V₁'. If the velocity is reduced by half and assuming the fluid properties are constant, the new convective heat transfer co-efficient is
For a laminar flow of fluid in a circular tube, 'h1' is the convective heat transfer co-efficient at velocity 'V1'. If the velocity is reduced by half and assuming the fluid properties are constant, the new convective heat transfer co-efficient is
Statement 1: Diffusion is faster than convective mass transfer. Statement 2: Mass transfer is proportional to the area of contact.
What will be the flux through the convective mass transfer when the mass transfer coefficient is 2 × 10-8 m/s and the change in the concentration is 25000 kg-mole/m3 and the eddy diffusion is 3 × 10-6 m2/s?
Consider a convective heat flow to water at 75 degree Celsius from a cylindrical nuclear reactor fuel rod of 50 mm diameter. The rate of heat generatioN is 50000000 W/m3 and convective heat transfer coefficient is I kW/m2 K. The outer surface temperature of the fuel element would be
Statement 1: Penetration theory states that mass transfer coefficient is directly proportional to diffusivity coefficient which was later proved wrong. Statement 2: Penetration theory states that mass transfer is based on unsteady mass transfer.
Read the given statements and conclusions carefully. Assuming that the information given in the statements is true, even if it appears to be at variance with commonly known facts, decide which of the given conclusions logically follow(s) from the statements. Statements: All Matter is Space. Some Mass is Matter. Conclusions: A. All Mass is Space. B. Some Mass is Space. C. Some Space is Mass. D. All Space is Mass. E. All Matter is Mass.
A rod of 10 mm square section and 160 mm length with thermal conductivity of 50W/m K protrudes from a furnace wall at 200 degree Celsius with convective coefficient 20 W/ square m K. Make calculations for the heat convective up to 80 mm length