Bissoy.com
Doctors Medicines MCQs Q&A

For a laminar flow of fluid in a circular tube, 'h1' is the convective heat transfer co-efficient at velocity 'V1'. If the velocity is reduced by half and assuming the fluid properties are constant, the new convective heat transfer co-efficient is

For a laminar flow of fluid in a circular tube, 'h1' is the convective heat transfer co-efficient at velocity 'V1'. If the velocity is reduced by half and assuming the fluid properties are constant, the new convective heat transfer co-efficient is Correct Answer 0.794 h<sub>1</sub>

Related Questions

For a laminar flow of fluid in a circular tube, 'h₁' is the convective heat transfer co-efficient at velocity 'V₁'. If the velocity is reduced by half and assuming the fluid properties are constant, the new convective heat transfer co-efficient is
In a counter flow heat exchanger, water flowing through a tube of 10 cm inner diameter is heated by steam condensing on the outside of the tube. The convective film coefficient on the water and steam side are estimated to be 12000 and 20000 k J/m2 hr degree. Neglecting tube thickness and its resistance to heat flow, workout the overall heat transfer coefficient for the heat exchanger
A stream of air at 100 kPa pressure and 300 K is flowing on the top surface of a thin flat sheet of solid naphthalene of length 0.2 m with a velocity of 20 m/sec. The other data are: Mass diffusivity of naphthalene vapor in air = 6 * 10 –6 m2/sec Kinematic viscosity of air = 1.5 * 10 –5 m2.sc Concentration of naphthalene at the air-solid naphthalene interface = 1 * 10 – 5 kmol/m3 Calculate the overage mass transfer coefficient over the flat plate. Note: For heat transfer over a flat plate, convective heat transfer coefficient for laminar flow can be calculated by the equation. Nu = 0.664 ReL1/2 Pr1/3 you may use analogy between mass and heat transfer.
A university library budget committee must reduce exactly five of eight areas of expenditure - I, J, K. L, M, N, O and P - in accordance with the following conditions: If both I and O are reduced, P is also reduced. If L is reduced, neither N nor O is reduced. If M is reduced, J is not reduced. Of the three areas J, K and N exactly two are reduced. If both K and N are reduced, which one of the following is a pair of areas neither of which could be reduced?
A university library budget committee must reduce exactly five of eight areas of expenditure—I, J, K, L, M, N, O and P—in accordance with the following conditions: If both I and O are reduced, P is also reduced.
If L is reduced, neither N nor O is reduced.
If M is reduced, J is not reduced.
Of the three areas J, K, and N exactly two are reduced. Question : If both K and N are reduced, which one of the following is a pair of areas neither of which could be reduced?
Which of the following statements is/are CORRECT regarding the flow of fluid? a) All fluid layers are parallel to each other in case of turbulent flow. b) The Reynold’s number is less than 2000 for turbulent flow and greater than 4000 for laminar flow. c) Two fluid layers don’t cross each other in case of laminar flow
Consider we have a Double Pipe Heat Exchanger, with the inner tube of Outer diameter 20mm (thickness 2mm) and outer tube of inner diameter 30mm. We have two fluids A & B, we desire to have their flow rates as 15 Kg/s and 21 Kg/s respectively. Calculate the convective heat transfer coefficient from tube to annulus side. (Given Nusselt number on tube side = 496 and K = 15W/mK)
Investigate the effect of following condition on the average value of heat transfer coefficient in flow through a tube Two fold increases in flow velocity by varying mass flow rate It may be presumed that there is no change in the temperature of the liquid and the tube wall, and that the flow through the tube is turbulent in character
Air flows through a 10 cm internal diameter tube at the rate of 75 kg/hr. Measurements indicate that at a particular point in the tube, the pressure and temperature of air are 1.5 bar and 325 K whilst the tube wall temperature is 375 K. Find heat transfer rate from one meter length in the region of this point The general non-dimensional correlation for turbulent flow in the tube is Nu = 0.023 (Re) 0.8 (Pr) 0.4 Where the fluid properties are evaluated at the bulk temperature
Experimental results indicate that the local heat transfer coefficient h g for flow over a flat plate with an extremely rough surface is approximated by the relation h x = a x -0.12 Where a is a constant coefficient and x is distance from the leading edge of the plate. What is the relation between this local heat transfer coefficient and the average heat transfer coefficient for a plate of length x?