Bissoy.com
Doctors Medicines MCQs Q&A

Determine the density, specific gravity, and mass of the air in a room whose dimensions are 4m × 5m × 6m at 100 kPa and 25° C.

Determine the density, specific gravity, and mass of the air in a room whose dimensions are 4m × 5m × 6m at 100 kPa and 25° C. Correct Answer 1.17 kg/m3, 0.00117, 140 kg

Related Questions

The following question, there are three statements I, II and III. Read the question carefully and mark your answer according to which statements(s) is/are sufficient to the answer the question. Find the total cost of flooring a room? Statement I: The length of the room is 70% more than the breadth of the room Statement II: The cost of flooring some other room whose length is twice the length of the given room and breadth is one third of the breadth of the given room is Rs.3000 less than the cost of flooring of given room Statement III: The perimeter of the room is 90 m and cost of flooring is Rs. 20 per m2
Hotel Aditya has 10 single AC rooms, 5 double AC rooms and 18 non AC rooms. The fixed monthly rent of hotel is 150,000. The per day maintenance cost is Rs. 100 for double AC room, Rs. 75 for single AC room and Rs. 40 for non AC room. The per day charges are Rs. 600 for double AC room, Rs. 400 for single AC room and Rs. 250 for non AC room. In April 2003, the occupancy rate of non AC room was 50%, 70% of single AC room and 40% of double AC rooms. Find the profit/loss % for that particular month.
Tina observed the following when she tested the specific gravity of milk to check for adulteration- the specific gravity was lesser than that of pure milk. She complained to the milk vendor and the next day checked the specific gravity again. This time it came in the range of the desired specific gravity. Can we be assured that this is pure unadulterated milk?
A cylinder/piston contains air at 100 kPa and 20°C with a V=0.3 m^3. The air is compressed to 800 kPa in a reversible polytropic process with n = 1.2, after which it is expanded back to 100 kPa in a reversible adiabatic process. Find the net work.
The average area of 2 rooms I and II are 400 square meters. If one rectangular room(III) area is added then the average area becomes 500 square meters. If another room IV, whose area is 600 square meters more than the III room, replaces room I, then the average area of II, III and IV room becomes 900 square meters. Find the area of I room.
The average area of 3 square rooms I, II, and III are 1600 square meters. If one rectangular room(IV) area is added then the average area becomes 1400 square meters. If another room V, whose area is 400 square meters more than the IV room, replaces room I, then the average area of II, III, IV, and V room becomes 1350 square meters. Find the area of I room.
A room whose length is 40% more than the breadth. The Perimeter of the floor of the room is 96 cm and the height of the room is 4/7 of the length of the room. If there is whitewashing in the room, the cost of whitewash is Rs.50 per cm2. Find the total cost in the whitewash of the whole room except the floor.
A stream of air at 100 kPa pressure and 300 K is flowing on the top surface of a thin flat sheet of solid naphthalene of length 0.2 m with a velocity of 20 m/sec. The other data are: Mass diffusivity of naphthalene vapor in air = 6 * 10 –6 m2/sec Kinematic viscosity of air = 1.5 * 10 –5 m2.sc Concentration of naphthalene at the air-solid naphthalene interface = 1 * 10 – 5 kmol/m3 Calculate the overage mass transfer coefficient over the flat plate. Note: For heat transfer over a flat plate, convective heat transfer coefficient for laminar flow can be calculated by the equation. Nu = 0.664 ReL1/2 Pr1/3 you may use analogy between mass and heat transfer.
An object X sinks in liquids P and Q but floats in liquid R. Which of the following conclusions can be made from these observations? A) Density of X is more than the density of P B) Density of X is less than the density of R C) Density of P is equal to the density of R D) Density of P is less than the density of R
Under which of the following condition(s) are the occluded fronts created? 1. When the front remains stationary 2. When cold air mass moves to warm air mass 3. When warm air mass moves to cold air mass 4. When an air mass is fully lifted above the land surface Select the correct answer using the code given below :