Bissoy.com
Doctors Medicines MCQs Q&A

A materials proof stress is also referred to as ___________

A materials proof stress is also referred to as ___________ Correct Answer proportional limit

Proof stress of a material can also be called a proportional limit. The procedure to find the elastic limit and proof stress are similar, but the quantities are different. Yield limit can be found through tension testing, but it is not the same as proof stress.

Related Questions

Which of the following statements regarding stress related factors is/are true and false?
1. Burnout Stress Syndrome (BOSS) is a debilirating psychological condition brought about by unrelieved work stress.
2. 'Good' and 'bad' stresses are also referred to as 'Distress' and 'Eustress' respectively.
3. It is natural and healthy to maintain optimal level of stress.
4. Rustout Stress Syndrome (ROSS) is indicative of stress overload.
5. Anxiety is a state of emotional tension characterised by Apprehension, fearfulness, and psychic pain.
Study the following information carefully to answer the question given below. Following are the qualifications and conditions for certain posts in a "XYZ" company. The candidate must: a) be an engineering graduate with at least 70% marks. b) be not less than 21 years and not more than 26 years of age as of 01/04/2018. c) have passed the written test with at least 60% of marks. d) be willing to pay a deposit of Rs. 2.5 lakh, to be refunded on completion of probation & training. If the candidate satisfies (a)-(d) he/she would be referred to as Engineer. However, if the candidate satisfies all the above, except: (i) at (a), has appeared for final semester exam; result yet to be declared; has 75% average marks up to the seventh semester; would be referred as Project-Engineer. (ii) at (a), has done diploma in engineering with 75% of marks, would be referred as Asst. Engineer. (iii) at (d), is willing to pay Rs. 1.5 lakh as a security deposit, would be referred to as Engineer-Trainee. (iv) at (b), even if age is above 26 years as of 1/4/18, but with 3 years of experience, would be referred as a Senior-Engineer. Pranita has completed her B. E. in electronics with 71% of the marks. She also has cleared the written tests with 75% of the marks. She is 22 years old as of May 2018. She is willing to pay a security deposit of Rs. 1.5 lakh. For which position will she be referred?
Study the following information carefully to answer the question given below. Following are the qualifications and conditions for certain posts in a “XYZ” company, The candidate must: a) be an engineering graduate with atleast 70% marks. b) be not less than 21 yrs and not more than 26 years of age as on 01/04/2018 c) have passed the written test with at least 60% of marks d) be willing to pay a deposit of Rs. 2.5 lakhs, to be refunded on completion of probation & training If the candidate is satisfied with (a)-(e) would be referred as Engineer. (i) at (a) but appeared final semester exam result yet to be declared with 75% average marks up to seventh semester be referred as Project-Engineer (ii) at (a) but has done diploma in engineering with 75% of marks be referred as Asst. Engineer (iii) at (d) be willing to pay Rs. 1.5 lakhs as security deposit he referred as Engineer-Trainee (iv) at (b) even if age above 26 years age as on 1/4/18 but with 3 years of experience be referred as Senior-Engineer Fatima is 28 years now in July 2018. She has completed B-E in information technology with 86% of marks. She has passed written test with 73% of marks. She is willing to pay Rs. 2.5 Lakhs of security deposit. She also had an experience of 3 years in the relevant field. For which position she will be referred? 
Descartes gives
1. causal proof.
2. cosmological proof.
3. non-causal proof.
4. non-cosmological proof.
Select the correct answer:
From an alloy, two specimens are machined and tested separately under tension and compression. The engineering stress-strain curves as well as the true stress-true strain curves for tension and compression are plotted in the same diagram. Identify the correct statements:
P. The engineering stress-strain curves in tension and compression are identical.
Q. The true stress-true strain curve in compression is lower than the true stresstrue strain curve in tension due to Bauschinger effect.
R. The true stress-true strain curve in tension is above the corresponding engineering stress-strain, curve.
S. The true stress-true strain curve in tension and compression are identical.
A materials proof stress is the highest stress possible for it to tolerate without causing a permanent set of more than ___________ inch per inch the length of gage, after the total release of stress.
The design stress, which is more than the damaging stress, is the least unit stress that will render a member unfit for service before the end of its normal life. The design stress factor or factor of safety indicates the margin between design stress and the __________ stress.
Tresca or maximum-shear stress criteria assumes that yielding occurs when the maximum shear stress reaches a value of the shear stress in the uniaxial tension test. Assume the principal stress being σ1, σ2, σ3 where σ1 is largest, and σ3 is the smallest principal stresses. Find the value of minimum shear stress to cause yielding, given that yield stress in tension is equal to σo?
The following are the conditions for selecting list of a suitable candidates to be called for interview after the written test for the recruitment is conducted/organized for management - level persons for a multi - national company. For providing accounting services and sales the candidate must (a) be holding a graduation in basic science with 65% or above or B.E. degree with 55% and above marks (b) have passed the written test with 70% or above marks (c) the age must be in the group 25 to 30 years as on 1/4/18 (d) have experience in an accounting firms for three years and diploma in accounting with 60% or above marks (e)  be presently drawing CTC of 6 Lakhs per annum and above In case the applicant who satisfies all other terms above except 1) at (a) above, then be referred as Junior Accountant 2) at (d) & (e) above then be referred as Trainee - Accountant Satisfying all the above with experience of 5 years then the referred as senior-Accountant Satisfying all the above criteria (a - e) with CA/ICWA/MBA (Finance) then be referred as manager (Accounts) Read all the above information and answer the following question Praveen has done his Masters in physics. He has no experience in accounting neither diploma. He is ready to be on training for accounting after joining. For which position he may be referred
The following are the conditions for selecting a list of suitable candidates to be called for interview after the written test for the recruitment is conducted/ organized for management-level persons for a multi-national company. For providing accounting services and sales the candidate must (a) beholding graduation in basic science with 65% or above or B.E. degree with 55% and above marks (b) have passed the written test with 70% or above marks (c) the age must be in the group 25 to 30 years as on 1/4/18 (d) have experience in an accounting firm for three years and a diploma in accounting with 60% or above marks e) be presently drawing CTC 6 lakhs per annum and above In case the applicant who satisfies all other terms above except 1) at (a) above, then be referred to as Junior Accountant 2) at (d) & (e) above then be referred to as Trainee-Accountant Satisfying all the above with experience of 5 years then be referred to as senior-Accountant Satisfying all the above criteria (a-e) with CA/ICWA/MBA (Finance) then be referred to as manager (Accounts) Read all the above information and answer the following question   Praveen has done his Masters in physics. He has no experience in accounting neither diploma. He is ready to be on training for accounting after joining. For which position he may be referred.