Bissoy.com
Doctors Medicines MCQs Q&A

There is no limit of the possible reduction in the thickness of the sheet metal, provided number of passes needs to increase.

There is no limit of the possible reduction in the thickness of the sheet metal, provided number of passes needs to increase. Correct Answer False

There is a lower limit below which the possible reduction of the material cannot be possible. This is because after a certain thickness, the roll itself starts deforming before the deformation in sheet metal occurs, thereby limiting the deformation of sheet metal.

Related Questions

Maslow's need-hierarchy theory of motivation has classified the human needs into five categories as follows. Arrange the following needs in ascending order given by Maslow
1. Safety needs
2. Esteem needs
3. Social needs
4. Physiological needs
5. Self-actualisation needs
What is the sequence of domtion of these needs?
In the hierarchical theory of Maslow, the needs are classified as 1. physiological needs 2. self - actualization needs 3. needs of belong 4. esteem needs 5. safety needs Which of the following is the correct sequence of the hierarchy of these needs from bottom to the top according to Maslow?
Which of the following is the correct order of human needs as formulated in Maslow's hierarchy of needs? a) Safety needs b) Love and belonging needs c) Physiological needs d) Self-actualisation needs e) Esteem needs Choose the most appropriate answer from the options given below:
A sheet of thickness 200 mm is rolled in a roller with roll diameter of 300 mm. If the coefficient of friction between the roll and sheet is 0.1. Find the minimum number of passes required to reduce the thickness of sheet to 180 mm?
Arrange the elements of Maslow's hierarchy of needs according to their arrangement of importance starting from the bottom of hierarchy.
1. Need for positive self image and recognition
2. Needs related to security, money, workplace
3. Psychological needs and basic needs
4. Needs of realising one's potential, continued growth
5. Needs related to love, affection, belongingness, acceptance
Thickness of 8 tyres L, M, N, O, P, Q, R and S is compared. Thickness of no two tyres is same. Thickness of N is more than L but less than 6 tyres. Thickness of O is more than M but less than Q. Thickness of P is less than only two tyres. Thickness of Q is not more than P. Which of the following statement is not correct?
A right angled triangle was cut from a rectangular sheet of length 20 cm whose perimeter is same as a square of side 30 cm. If height of the triangle is same as breadth of rectangular sheet and base is 1/4th of length of sheet then, the area of the remaining sheet is what percent of area of the whole sheet?
Consider the following statements: 1. When a soil sample is dried beyond its shrinkage limit, the volume of the soil slowly decrease 2. The plastic limit is always lower than the liquid limit for any type of soil 3. At the liquid limit, the soil behaves like a liquid and possesses no shear strength at all 4. When subjected to drying, the volume of the soil remains unchanged once the water content of the soil goes below its shrinkage limit Which of the above statements are correct? 
What are the different limit states of design as per IS 456: 2000? a. Limit state of failure b. Limit state of damage c. Limit state of collapse d. Limit state of serviceability
In the given diagram, the sheet of thickness h1 is reduced to thickness h2. Find the correct relation between the velocity of the sheet? Where v1 is entering velocity and v2 is exiting velocity. Assuming the width of the sheet is constant.