Bissoy.com
Doctors Medicines MCQs Q&A

The steady-state creep (secondary state) has constant creep due to the competing result of the strain hardening and recovery.

The steady-state creep (secondary state) has constant creep due to the competing result of the strain hardening and recovery. Correct Answer True

In the initial state, the creep rate is decreasing because the creep resistance of the material increases. After this stage, the strain hardening and recovery process starts counteracting each other, and the creep rate becomes steady, hence constant creep rate.

Related Questions

From an alloy, two specimens are machined and tested separately under tension and compression. The engineering stress-strain curves as well as the true stress-true strain curves for tension and compression are plotted in the same diagram. Identify the correct statements:
P. The engineering stress-strain curves in tension and compression are identical.
Q. The true stress-true strain curve in compression is lower than the true stresstrue strain curve in tension due to Bauschinger effect.
R. The true stress-true strain curve in tension is above the corresponding engineering stress-strain, curve.
S. The true stress-true strain curve in tension and compression are identical.
Strain hardening due to ___________ process arises from short range force occurring over a distance of 5 to 10 atomic distance. This hardening can be overcome at finite temperatures with the help of thermal fluctuations, and therefore, it is temperature and strain-rate-dependent.
The true strain rate is given as ϒ, and conventional strain rate is given as ε. The engineering strain is equal to e. The relationship between conventional strain rate and true strain rate is _______
The rate of strain hardening and strain hardening exponents in the flow curve is always the same.
Consider the following statements: 1. Secondary consolidation occurs at constant effective stress. 2. Secondary consolidation is related to dissipation of pore water pressure 3. Secondary consolidation occurs due to the readjustment of soil skeleton after a disturbance during primary consolidation. 4. Rate of secondary consolidation is controlled by the viscous adsorbed layer surrounding clay particle in soil. Which of the above statements are correct?
In the flow curve equation given below, if the value of strain hardening exponent is increased, what will be the effect on the ductility of material? σ=Kεn; Where n is strain hardening exponent.
Study the following statements regarding creep.
i) Creep is greater on curves than on tangent railway track
ii) Creep in new rails is more than that in old rails
iii) Creep is more on steep gradients than on level track
The correct answer is
Consider three software items: Program-X, Control Flow Diagram of Program-Y and Control Flow Diagram of Program-Z as shown below Program-X: Control Flow Diagram of Program-Y sumcal (int maxint, int value) {       int result=0, i=0;       if (value <0)       {           Value = -value;       }       while ( (i
The only suitable method for hardening the low carbon steel is case hardening. Which of the following is a case hardening process?
The following flow curve shows the deformation behavior of the material in the plastic region. The material is deformed till ε1 and released; the material immediately reached to strain ε2. And the time strain reached to ε3. So, there is a delayed recovery of strain. This is behavior of material is called _________