Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Compared to mild steel, cast iron has (i) High compressive strength (ii) High tensile strength (iii) Low compressive strength (iv) Low tensile strength
Compared to mild steel, cast iron has
(i) High compressive strength
(ii) High tensile strength
(iii) Low compressive strength
(iv) Low tensile strength
If the sample is tested for a large number of cycles below its fatigue limit and the stress is gradually increased above the fatigue limit, the true fatigue limit of material will _______
Which variety of cast iron is obtained by melting cast iron with wrought iron scrap?
Malleable cast iron is produced 1. By quick cooling of cast iron. 2. By adding magnesium to molten cast iron. 3. from white cost iron by annealing. Which of the above statements is/are correct?
Calculate ultimate moment and shear of effective span is 30m, live load is 9kn/m, dead load excluding self weight is 2kn/m, load factors for dead load is 1.4 for live load is 1.6 cube strength of concrete fcu is 50n/mm2 cube strength at transfer is fci is 35n/mm2, tensile strength of concrete Ec is 34kn/mm2 loss ratio ɳ is 0.85 and 8mm diameter high tensile strength fpu is 1500n/mm2 are available for use and the modulus of elasticity of high tensile wires is 200kn/mm2?
Which of the following statements are correct? 1. Steel and cast iron are multi-phase alloys. 2. Ferrite is a single phase interstitial solid solution of carbon in iron. 3. Wrought iron is a highly refined iron with a small amount of slag which gives resistance to progressive corrosion. 4. Stellite contains large amounts of metals like cobalt and tungsten resulting in high hardness. Select the correct answer using the code given below.
A material is a fatigue tested below the fatigue limit for few millions of cycles and then retested at higher than fatigue limit. This process is known as ___________
Consider the following statements: 1. When a soil sample is dried beyond its shrinkage limit, the volume of the soil slowly decrease 2. The plastic limit is always lower than the liquid limit for any type of soil 3. At the liquid limit, the soil behaves like a liquid and possesses no shear strength at all 4. When subjected to drying, the volume of the soil remains unchanged once the water content of the soil goes below its shrinkage limit Which of the above statements are correct? 
The yield point in fatigue loading compared to that in static loading is less. The ratio of ultimate tensile strength to endurance limit of a material subjected to fatigue loading is