Bissoy.com
Doctors Medicines MCQs Q&A

Slip begins when the shearing stress on the slip plane in the slip direction reaches a threshold value called the critical resolved shear stress.

Slip begins when the shearing stress on the slip plane in the slip direction reaches a threshold value called the critical resolved shear stress. Correct Answer True

The extent of the slip in a single crystal depends on the magnitude of the shearing stress produced by external loads, the geometry of the crystal structure, and the orientation of the active slip planes concerning the shearing stresses. Slip begins when the shearing stress on the slip plane in the slip direction reaches a threshold value called the critical resolved shear stress.

Related Questions

Which of the following factors are affecting critical shear stresses? 1. Purity of metals reduces the critical shear stress 2. Surface films greatly enhance the critical shear stress 3. Rise in temperature 4. Rate of deformation and the extent of initial deformation also help in raising the critical shear stress
Tresca or maximum-shear stress criteria assumes that yielding occurs when the maximum shear stress reaches a value of the shear stress in the uniaxial tension test. Assume the principal stress being σ1, σ2, σ3 where σ1 is largest, and σ3 is the smallest principal stresses. Find the value of minimum shear stress to cause yielding, given that yield stress in tension is equal to σo?
Consider the following statements: X. Two-dimensional stresses applied to a thin plater in its own plane represent the plane stress condition. Y. Normal and shear stresses may occur simultaneously on a plane. Z. Under plane stress condition, the strain in the direction perpendicular to the plane is zero. Which of the above statements are correct?
The following diagram shows a positive edge dislocation. The AA’ shows the slip plane for the dislocation. Above the slip plane stress is _________ in nature, and below the slip plane stress is _______ in nature.
There are three metals given below. Metal A – Very few numbers of the slip systems Metal B – High critical resolved shear stress Metal C – High number of the slip system Which of the following is more susceptible for twining?
What is the resolved shear stress, when dislocation density in metal is equal to 1012m-2? Given that shear stress needed in the absence of dislocation is 500MPa. Numerical constant is 0.3 and shear modulus is 80GPa, burger vector is 1 nm.
A body is subjected to a tensile stress of 1200 MPa on one plane and another tensile stress of 600 MPa on a plane at right angles to the former. It is also subjected to a shear stress of 400 MPa on the same planes. The maximum shear stress will be
The Rheological behaviour of concrete, when represented by shear stress vs rate of shear, is characterized as Where : τ shear stress, Τ0 = (initial) yield value, μ = at-point plastic viscosity, γ̇ = at point rate of shear.
Consider the following statements for Euler’s equation to find the critical load of a column : 1. Critical load of a column is proportional to the flexural rigidity. 2. Critical load of a column depends upon yield stress. 3. Critical load of a column is inversely proportional to the length of the column. 4. Critical load of a column is inversely proportional to the square of the length of the column. Which of the above statements are correct?
A solid rod of circular cross-section made of brittle material, when subjected to torsion, fails along a plane at 45° to the axis of the rod. Consider the following statements as pertaining there to: 1. Distortion energy is maximum on this 45° plane. 2. Shear stress is maximum on this 45° plane. 3. Normal stress is maximum on this 45° plane. Which of the above is/are correct?