Bissoy.com
Doctors Medicines MCQs Q&A

Von-mises or Distortion-energy Criteria proposed that yielding will occur when the second invariant of the stress deviator J2 exceeds some critical value. The second invariant of the stress deviator J2 is equal to __________ b) 1/2 c) d) 1/2

Von-mises or Distortion-energy Criteria proposed that yielding will occur when the second invariant of the stress deviator J2 exceeds some critical value. The second invariant of the stress deviator J2 is equal to __________ b) 1/2 c) d) 1/2 Correct Answer 1/6

Von-mises proposed the idea that distortion stress of any material should be independent of the principal stress direction. In other word, it must result in an invariant quantity which is equal to 1/6 .

Related Questions

Tresca or maximum-shear stress criteria assumes that yielding occurs when the maximum shear stress reaches a value of the shear stress in the uniaxial tension test. Assume the principal stress being σ1, σ2, σ3 where σ1 is largest, and σ3 is the smallest principal stresses. Find the value of minimum shear stress to cause yielding, given that yield stress in tension is equal to σo?
Stress analysis of structural material for the submarine gives the state of stress as shown in the figure. The yield strength of the material is 450 MPa. Using Von-mises yielding criteria determine whether yielding will occur or not? If not, what is the factor of safety?
Stress analysis of structural material for the submarine gives the state of stress as shown in the figure. The yield strength of the material is 450 MPa. Using Tresca’s yielding criteria determine whether yielding will occur or not? If not, what is the factor of safety?
Study the following information carefully and answer the question given below. The following criteria have been introduced for the appointment of a scientist in a research organization. Candidates: 1) Must be a postgraduate in Mathematics/Physics/Chemistry subject with a minimum of 65% marks 2) Age should not be less than 26 years and not more than 35 years as on 01-01-2018 3) Must have a post-doctoral degree with more than 50% marks 4) Should have a minimum of 3 years of experience in the above fields 5) Should be prepared to be under probation for one year If the candidate satisfies all the criteria other than (3), he may be designated as Project Scientist. If the candidate satisfies all the above criteria other than (3) and (4) he may be referred for the post of Junior Scientist. If the candidate fulfills all the above criteria with 7 years of experience in the relevant fields, he/she can be designated as a Senior Scientist. If the candidate fulfills all the above criteria with 12 years of experience in the relevant field, he/she can be designated as Principal Scientist. Varun's age is 27 years as of 1/1/18, he obtained his bachelor's and master's degree in chemistry with 72% and 76% marks respectively. He also had 4 years of experience in the relevant field and was ready to be under probation for one year of the job. to what position he may be assigned
Physical Meaning of von-mises yielding criteria is that yielding occurs when the _____________ reaches a critical value.
According to Von-mises, yielding occurs when J2 exceeds some constant k2 So, the minimum condition for yielding is J2=k2 Find the value of k in uniaxial tension. Given that yield strength = σo
Which of the following factors are affecting critical shear stresses? 1. Purity of metals reduces the critical shear stress 2. Surface films greatly enhance the critical shear stress 3. Rise in temperature 4. Rate of deformation and the extent of initial deformation also help in raising the critical shear stress
The value of constant k in Tresca’s yielding criteria in case of pure shear will be equal to ___________ Given that Principle stress being σ1, σ2, σ3 and yield stress in tension and pure shear are equal to σo and τ.
Consider the following statements for Euler’s equation to find the critical load of a column : 1. Critical load of a column is proportional to the flexural rigidity. 2. Critical load of a column depends upon yield stress. 3. Critical load of a column is inversely proportional to the length of the column. 4. Critical load of a column is inversely proportional to the square of the length of the column. Which of the above statements are correct?
The yielding criteria are primarily empirical relations. Pure hydrostatic stress causes the yielding in continuous solid.