Bissoy.com
Doctors Medicines MCQs Q&A

If the drying operation is concerned as a setup, adiabatic dryers are __________ non-adiabatic dryers.

If the drying operation is concerned as a setup, adiabatic dryers are __________ non-adiabatic dryers. Correct Answer Less expensive than

Adiabatic dryers are less expensive although they have low efficiency because there is an insulating cover that does not allow heat to escape, which saves the industry of heating cost and increases thermal efficiency in the cost of drying efficiency.

Related Questions

Statement 1: Drying is used for preservation of food. Statement 2: Convective drying is indirect drying and conductive drying is direct drying.
200 kg of solids (on dry basis) is subjected to a drying process for a period of 5000 seconds. The drying occurs in the constant rate period with the drying rate as, Nc = 0.5 × 10-3 kg/m2.s. The initial moisture content of the solid is 0.2 kg moisture/kg dry solid. The interfacial area available for drying is 4 m2/1000 kg of dry solid. The moisture content at the end of the drying period is (in kg moisture/kg dry solid)
A solid is being dried in the linear drying rate regime from moisture content Xo to XF. The drying rate is zero at X = 0 and the critical moisture content is the same as the initial moisture Xo. The drying time for M = (Ls/ARc) is (where, L = total mass of dry solid, A = total surface area for drying Rc = Constant maximum drying rate per unit area X = moisture content (in mass of water/mass of dry solids)
We have a triple effect evaporator which has steam supply of 5kg/hr, the setup is a forward pass setup, feed enters the 1st setup at 10kg/hr of 50% concentration and leaves the final effect at 75% concentration. What is the product discharged from this setup?
We have a triple effect evaporator which has steam supply of 5kg/hr, the setup is a forward pass setup, the feed enters the 1st setup at 10kg/hr of 50% concentration and leaves the final effect at 75% concentration. What is the economy of this setup?
A dryer is used for drying pears which has initial moisture content of 70 % (wet basis) and final moisture content of 5 % (wet basis). An experimental drying curve for the product indicates that the critical moisture content is 25 % (wet basis) and the time for constant drying is 5 min. Can you estimate the total drying time for product?
We have a triple effect evaporator which has steam supply of 5kg/hr, the setup is a forward pass setup, feed enters the 1st setup at 10kg/hr of 50% concentration and leaves the final effect at 75% concentration. What is the evaporate discharged if the total evaporate from 1st and 2nd effect are 2kg/hr and 1kg/hr respectively?
A party can be recognized as a State Party when : i. it secures 6% of the total valid votes polled in the state at a general election to the Legislative Assembly of the state concerned ii. it wins 2 Assembly seats at a general election to the Legislative Assembly of the state concerned iii. it secures 4% of the total valid votes polled in the state at a general election to the Lok Sabha of the state concerned iv. it secures 6% of the total valid votes polled in the state at a general election to the Lok Sabha of the state concerned
Which of the following category is NOT a right classification of the bills introduced in the Parliament? Ordinary bills, which are concerned with any matter other than financial subjects. Currency bills, which are concerned with the financial matters like taxation, public expenditure, etc. Financial bills, which are also concerned with financial matters ,also called as money bills. Constitution amendment bills, which are concerned with the amendment of the provisions of the Constitution.
Normally, the length to diameter ratio of rotary dryers varies form 4 to 10 and for its economic operation, the number of transfer units (NTU) for such dryers varies from